Overview
The AP-HX-1000D programmable humidity chamber is an environmental test equipment produced by APKJ, which mainly provides complex high and low temperature alternating test environments and conditions for electronic parts, industrial materials, finished product research and development, production, and inspection. The equipment adopts a 7-inch large touch AP-900 intelligent programmable temperature and humidity controller, which supports 120 sets of programs, each set of 100 segments, with program circulation, connection and data recording functions.
Features
1. Adopt 7-inch large touch AP-900 intelligent programmable temperature and humidity controller, support 120 sets of programs, each set of 100 segments, can set the program full cycle, partial cycle and program connection
2. The controller can be connected to the computer through the LAN interface, enabling remote programming, data collection, and machine switch control
3. The multi-wing blower has strong air circulation to ensure uniform indoor temperature and humidity distribution without dead ends
4. Complete safety protection device, automatically displaying fault status and cutting off power when abnormal, providing Troubleshooting method
5. Adopt original imported Compressor (France Taikang or Japan Hitachi) and high-quality refrigeration components to ensure efficient and stable operation
Principle
The equipment works together through the control panel, switchboard, thermal insulation compartment, blower, heater, humidifier, freezer and other components to achieve temperature and humidity control. Multi-wing blower is used for strong air circulation to avoid dead ends and ensure uniform distribution of temperature and humidity. The refrigeration system adopts primary compression or binary cascade refrigeration mode, through expansion valve and capillary tubing throttling, and cooperates with finned tube heat exchanger to achieve heat exchange.
Applications
Electronics Communication, Chemical, Hardware, Rubber, Toys, Scientific Research
Standards
GB/T10589-2008、GB/T10586-2006、GB/T10592-2008、GB/T2423.1-2008、GB/TT2423.2-2008、GB/T2423.3-2006、MIL-STD810D、GB/T2423.4-2008、GJB150.9-1986、GB2423.34-2012、MIL-STD883C
Steps
1. Ensure that the installation site does not have strong vibration, strong electromagnetic field, the ground is flat and ventilated, and reserve maintenance space
2. Configure independent AC220V power supply, meet single-phase two-wire + protective ground wire, voltage range AC (220 +/- 10) V, frequency (50 +/- 0.5) Hz, protective ground wire grounding resistance less than 4Ω
3. Programming and parameter setting through the controller or computer connection LAN interface
4. Start the equipment, monitor the running status, and follow the fault prompts when abnormal.
Notice
○ It is forbidden to test or store flammable, explosive, volatile matter, corrosive substances, biological samples, and strong electromagnetic emission source samples
The installation site should be free from strong vibration, strong electromagnetic field, flammable and explosive corrosive substances and dust
○ The power supply needs to be configured independently, meeting the requirements of AC220V single-phase two-wire + protective ground wire, and the voltage fluctuation does not exceed +/- 10%
○ The equipment does not include ventilated pipes, power cables, leakage switches, gas sources, water sources and other external environment installation items
○ The working environment temperature should be kept at 5~ 30 ℃, humidity ≤ 85%, air pressure 86kPa~ 106kPa
