Overview
Oven coil automatic composite Coater is a small Spreader composite machine, suitable for water-based adhesive Spreader paper, film, aluminum foil, plastic, non-woven fabrics and other non-elastic materials. The equipment integrates the functions of unwinding, scraping, drying, overlaying and winding, and realizes automatic composite Spreader operation.
Features
1. Spreader mode is flexible, support scraper and roller coatings to switch freely; 2. Adjustable bonding speed, range of 1~ 10m/min, servo control accuracy is high; 3. Spreader width and Film thickness adjustable, width 100~ 300mm, Film thickness 0.005-3mm; 4. Equipped with deviation correction device, automatic adjustment of material alignment; 5. Drying tunnel temperature adjustable, range RT +~ 200 ℃, to ensure drying effect; 6. Compact equipment structure, using aluminum alloy and high electrostatic spray plate, durable and beautiful.
Principle
The equipment provides the substrate through the discharge rack, the coating roller group performs Spreader, and the Film thickness adjustment dial meter controls the Spreader Film thickness. After Spreader, the substrate is smoothly transferred to the drying tunnel through the transmission platform, and then pulled to the cladding process through the traction roller group to realize the automatic composite and winding of the material. The deviation correction device automatically adjusts the material alignment during the cladding process.
Applications
Paper, film, aluminum foil, plastic, non-woven fabric
Steps
1. Place the substrate on the discharge rack; 2. Adjust the gluing width and Film thickness to the required parameters; 3. Start the equipment, and the substrate passes through the coating roller group Spreader; 4. After Spreader, the substrate enters the drying tunnel through the transmission platform; 5. After drying, the substrate is pulled by the traction roller group to the coating process; 6. Automatic winding after completion of compounding.
Notice
• Make sure the Power supply voltage is 220V before operation to avoid overload; • When adjusting the thickness of the Spreader Film, adjust it accurately according to the indicator of the percentage table; • When pulling the substrate, tighten the hand wheel to make the traction roller contact to prevent slipping; • The temperature of the drying tunnel shall not exceed 200 ° C to prevent material damage; • Regularly check the deviation correction device to ensure accurate material alignment; • Pay attention to safety when the equipment is running and avoid contact with moving parts.
