Overview
Automatic film applicator is an oven coil automatic film applicator for non-elastic materials such as water-based adhesive Spreader paper, film, aluminum foil, plastic, non-woven fabrics, etc. The equipment integrates the functions of unwinding, scraping, drying and winding, and adopts the body structure composed of aluminum alloy and high electrostatic spray plate.
Features
1. The body is composed of aluminum alloy and high electrostatic spray plate, and the structure is stable and durable
2. Equipped with a gluing width adjustment device, composed of food-grade plastic and adjustable braces
3. Configure two discharge racks with automatic deviation correction function to ensure material alignment
4. The coating roller group is made of double-drum precision machining parts, with smooth transmission
5. Equipped with a thickness adjustment dial meter to precisely control the thickness of the Spreader
6. The transmission platform is made of stainless steel to ensure smooth transmission of the substrate
7. The design of the traction roller group is reasonable, which is convenient for the substrate traction and Spreader to complete
Principle
The device sends the substrate into the coating roller group for scraping through the discharge rack, and the thickness of the Spreader is controlled by adjusting the dial table. The substrate after the Spreader is smoothly transferred to the drying tunnel through the transmission platform for drying, and finally the winding is completed through the traction roller group. The deviation correction device automatically adjusts the position of the material rack during the lamination process to ensure the alignment of the material.
Applications
Paper, film, aluminum foil, plastic, non-woven fabric
Steps
1. Place the substrate on the discharge rack
2. Adjust the glue width device to the desired width
3. Set the Spreader thickness through the thickness adjustment dial
4. Drag the substrate between the upper and lower rollers of the traction roller
5. Tighten the rack handwheel to make the traction roller contact the substrate
6. Start the device for Spreader operation
7. Monitor the drying temperature to ensure the drying effect
8. Wrap up the material after finishing the Spreader
Notice
• Spreader thickness adjustment needs to be precisely controlled according to the indicator
The contact pressure of the traction roller should be appropriate to avoid damage to the substrate
• The drying tunnel temperature needs to be adjusted within the range of RT +~ 200 ° C
• Power supply voltage is 220V before running
• When operating, pay attention to the coating speed control of 1~ 10m/min
• Regularly check the status of the coating roller group and transmission parts
• Ensure that the material width is within the adjustable range of 100~ 500mm
