Overview
The hot-melt adhesive coating and cutting machine is an industrial production equipment used to Spreader hot-melt adhesive on the surface of different materials. It has the functions of unwinding, scraping, Laminating, slitting and winding. The maximum Spreader width of the machine is 400mm, and the two Teflon baffles in the plastic slot can easily adjust the application width. It supports unlimited length Spreader gluing, and has automatic winding function. The Spreader speed can be adjusted from 2 to 4.5m/min.
Features
1. The maximum Spreader width is 400mm, and the hiking width is adjusted by two Teflon baffles in the rubber slot
2. Unlimited length Spreader can be glued and automatically rolled
3. Forward and reverse continuously variable speed
4. The discharge reel can adjust the knob to change the tension discharge
5. The reel can be adjusted by mechanical tension control
6. The heating rod, upper rubber wheel and rubber slot can be quickly disassembled and separated from the body to remove the residual glue
Principle
The equipment uses the heating trough to heat the hot-melt adhesive to a set temperature, uses the scraping method to evenly Spreader the hot-melt adhesive on the surface of different materials, controls the Spreader speed through positive and reverse stepless speed change, and realizes continuous production by unwinding and winding system. The slitting module can cut the material.
Applications
Materials gluing, sealing, coating in industrial production environments
Steps
1. Adjust the Teflon baffle setting application width in the glue slot
2. Set the heating trough temperature to the desired range
3. Adjust the tension knob of the discharge reel
4. Set the Spreader speed within the range of 2~ 4.5m/min
5. Start the device for Spreader operation
6. Adjust the mechanical tension control of the reel
7. Use the slitting module for material cutting
8. Clean up the residual glue after the equipment is completed
Notice
• Spreader thickness range should be controlled between 0.01mm~ 2mm
• The heating trough temperature must not exceed 200 ° C
• Recommended Spreader speed is 4.5m/min
• Power supply voltage requires AC 380V (single phase)/50Hz
• Regularly clean up the residual glue on the heating rod, the glue wheel and the glue slot
• Pay attention to adjust the discharge and receipt tension during operation to ensure Stability
