Overview
The Rxg-01/300cs is a high-efficiency multi-functional equipment that integrates unwinding, Spreader, laminating, drying and slitting. Its effective Spreader width reaches 300mm, and the production speed can be adjusted to 5 meters/minute. It is driven by a stepper motor, equipped with a tension control system and a Touchscreen operation interface. It covers an area of only 2.3 square meters and is suitable for the precision production of film products such as mouth-dissolved films.
Features
1. Integrated design, integrated unwinding, Spreader, laminating, drying, slitting functions.
2. The width of the Spreader can reach 300mm, and the production speed can be adjusted from 0 to 5 meters per minute.
3. Driven by a stepper motor and equipped with a tension control system, it runs smoothly.
4. The operation interface is Touchscreen (Kunlun Tongtai), which is convenient to control.
5, High Accuracy Hob type cross cutting, cutting precision.
6. Equipped with an automatic deviation correction device to ensure material alignment.
7. Film thickness can be precisely adjusted by dial indicator.
8. Compact structure and small footprint (approximately 2.3 square meters).
9. The body adopts aluminum alloy and high electrostatic spray plate, and the transmission platform is made of stainless steel, which has good durability.
Principle
The device releases the substrate through the unwinding device, and performs Spreader through the coating roller group. The thickness of the Spreader Film can be adjusted by the dial meter and the handwheel. The substrate after the Spreader is smoothly transported through the transmission platform and advanced under the action of the traction roller group, which can be used for the bonding process. Then the material enters the drying stage, and finally it is cut by the High Accuracy hob type cross-cutting device to complete the continuous production process from raw materials to finished products.
Applications
Mouth-soluble film, film products
Steps
1. Install the substrate on the discharge rack.
2. Set relevant parameters through Touchscreen.
3. Manually pull the substrate between the upper and lower rollers of the traction roller.
4. Tighten the rack handwheel to make the rubber ring of the upper roller of the traction roller come into contact with the lower roller.
5. Start the equipment, and the traction roller group will pull the substrate to complete the Spreader work.
6. Adjust the thickness of the glue by swirl/spin coating the left and right handwheels on the rubber roller frame and refer to the indicator.
7. After the material is Spreader, bonded and dried, it is cut by the slitting device.
Notice
The power supply of the equipment host is 380V, so ensure that the power supply matches.
* Pay attention to the precise control of Spreader Film thickness through the dial table when operating.
When pulling the substrate, ensure that the material passes through the traction roller group correctly.
When using the deviation correction device, pay attention to the alignment of the materials.
Maintain equipment regularly to ensure that components such as coatings, tools, etc. work properly.
Pay attention to the equipment footprint requirements to ensure sufficient installation space.
