Overview
Rxg-01/300hp small coil oven Coater is a multi-functional equipment integrating Spreader, drying, hot pressing and winding. It is specially designed for coating and compounding process of coil surface. The machine adopts aluminum alloy and high electrostatic spraying plate body, with compact structure, adjustable Spreader width and Film thickness, and is suitable for precision Spreader and lamination of various materials.
Features
1. The structure is sturdy and durable, and the body is composed of aluminum alloy and high electrostatic spray plate.
2. Equipped with double discharge racks and automatic deviation correction device to ensure accurate alignment of the cladding materials.
3. The coating roller group is made of double-drum precision machining parts, with smooth transmission.
4. Spreader Film thickness can be finely adjusted by hand wheel with dial meter.
5. The transmission platform is made of stainless steel to ensure the smooth transmission of the substrate.
6. Adjustable coating speed and drying tunnel temperature, strong process adaptability.
7. Integrated drying tunnel and double-roll hot pressing function to achieve continuous operation of Spreader, drying and laminating.
Principle
The device releases the substrate through the discharge rack, the substrate is glued through the coating roller group, and the gluing Film thickness is controlled by the adjustment handwheel and the dial meter. Subsequently, the glued substrate enters the drying tunnel through the stainless steel transmission platform for drying, and then is bonded and pressed through the double-roll hot-pressing device. Finally, it is pulled by the traction roller group to complete the Spreader and composite process, and the winding part completes the winding.
Applications
Coil Surface Coating, Material Composite, Adhesive Tape Production, Protective Film Spreader, Electronic Material Processing
Steps
1. Install the substrate on the discharge rack and pass through the automatic deviation correction device.
2. According to requirements, set the Spreader width through the glue width adjustment device.
3. swirl/spin the left and right handwheels on the rubber roller frame, refer to the indicator, adjust to the required film thickness.
4. Manually pull the substrate between the upper and lower rollers of the traction roller.
5. Tighten the handwheel on the rack, so that the rubber ring of the upper roller of the traction roller is in contact with the lower roller, and press the substrate tightly.
6. Start the equipment, set the coating speed and drying temperature, and start the continuous operation of Spreader, Drying, Hot Pressing and Winding.
Notice
• Before operation, make sure that the Power frequency is 380V and check whether the equipment is grounded reliably.
• When adjusting the film thickness, please slowly swirl/spin the handwheel and closely observe the dial meter reading to avoid excessive adjustment.
When pulling the substrate, pay attention to hand safety and avoid getting involved in the roller group.
• During the operation of the equipment, do not touch high temperature parts such as drying tunnels and hot pressing rollers.
• The maximum roll diameter of discharge and receipt is 300mm, please do not use it beyond the limit.
• Regularly clean the coating roller group and transmission platform to keep the equipment clean.
• Non-professionals should not disassemble or adjust the core transmission components of the equipment.
