Overview
UV UV curing coil Automatic Film Applicator Rvadh-04/500uv is a coil laminating machine with UV curing, with automatic laminating function, scratch coating method, and equipped with 1 meter oven, suitable for Spreader UV glue on release film.
Features
1. Adopt micro-concave + comma double Spreader head design, which can be switched.
2. Equipped with 1 meter oven and UV light curing system, curing area 300 * 500mm.
3. Production speed 0-5m/min adjustable, effective Spreader width up to 500mm.
4. Adopt Touchscreen (Kunlun Tongtai) control, easy to operate.
5. The unwinding has tension control, and the air expansion shaft is used for unwinding and unwinding.
6. Spreader process is complete, including unwinding, scraping, drying, UV curing, winding and other steps.
Principle
The device releases the substrate (release film) through the unwinding mechanism, and the UV glue is evenly Spreader on the surface of the substrate through the scraping head. Subsequently, the material after the Spreader enters a 1-meter-long oven for preliminary drying, and then passes through the UV light curing area. The glue is rapidly cured under ultraviolet light irradiation of a specific wavelength (main peak 365nm, range 350-450nm), and finally the winding mechanism completes the winding.
Applications
Suitable for coating UV glue on release film
Steps
1. Unwinding: Install the release film roll to the unwinding shaft and set the tension control.
2. Scratch: Select the slightly concave or comma Spreader head to perform UV glue Spreader.
3. Drying: Spreader the material into a 1 meter oven for drying.
4. UV curing: The material is cured through the UV light curing area.
5. Winding: The material completed by curing is rolled into rolls by the winding mechanism.
Notice
• Power frequency of the device is three-phase 220V, please make sure the power supply matches.
• Please check whether the air expansion shaft, switch (aviation plug/separate switch) and other components are normal before operation.
• Pay attention to the wavelength range of UV light (350-450nm) and curing area (300 * 500mm) to ensure safety protection.
The production speed can be adjusted within the range of 0-5m/min as required.
• Please perform device operation and parameter settings through Touchscreen.
