Overview
Small Spreader Rxg-0.5/300 is an oven coil automatic composite Coater for water-based adhesive Spreader. It integrates unwinding, scraping, drying, overlaying and winding functions, and is specially designed for paper, film, aluminum foil, plastic, non-woven fabrics and other non-elastic materials.
Features
1. Adopt scraping method, equipped with dual Spreader head device, can switch between scraping and free Spreader mode.
2. Spreader Film thickness adjustment range is wide, 0.005-3mm, through precision dial meter precise control.
3. Equipped with automatic deviation correction function, ensure that the two materials are precisely aligned during the lamination process.
4. The bonding speed is controlled by the servo and can be finely adjusted within the range of 0.1m/min to 10m/min.
5. Coating roller and laminating roller can be heated, temperature range from room temperature to 200 ℃.
6. The body adopts aluminum alloy and high electrostatic spray plate structure, and the transmission platform is made of stainless steel to ensure the stability and durability of the equipment.
Principle
The device provides the substrate through the discharge rack. When the substrate passes through the coating roller group, the water-based glue is evenly Spreader by the scraping device. The thickness of the Spreader Film is controlled by adjusting the handwheel and the dial meter. Subsequently, the substrate after the Spreader is smoothly transported to the drying tunnel through the transmission platform for drying, and then accurately overlapped with another material at the heated bonding roller through the traction roller group. Finally, the winding device completes the winding. The whole process is driven by the transmission mechanism to realize continuous automated operation.
Applications
Spreader and composite of non-elastic materials such as paper, film, aluminum foil, plastic and non-woven fabric
Standards
The data did not mention specific compliance criteria
Steps
1. Install the substrate on the discharge rack and ensure alignment through a deviation correction device.
2. According to requirements, adjust the gap between the coating roller through the handwheel and the dial meter, and set the Spreader Film thickness.
3. Manually pull the substrate to the coating roller group for Spreader.
4. Spreader the substrate through the transmission platform into the drying tunnel.
5. Another material is introduced, passed through the traction roller group together with the dried substrate, and laminated at the heated bonding roller.
6. Tighten the hand wheel on the traction roller frame to make the upper and lower rollers contact, and start the equipment to complete automatic winding.
Notice
• This device is suitable for non-elastic materials, do not use for resilience materials.
• Before operation, make sure that the Power frequency is 220V and check whether the equipment is well grounded.
• When adjusting the Spreader Film thickness, please swirl/spin the handwheel slowly and refer to the percent representation to avoid sudden and large adjustments.
• During the operation of the equipment, do not touch the coating roller, traction roller and heating parts with your hands to prevent burns or involvement.
• Regularly clean the coating roller group and transmission platform to prevent glue residues from affecting Spreader mass and equipment operation.
• The maximum discharge and receipt width of the equipment is 300mm, please do not use it beyond the limit.
