Overview
The desktop roll-to-roll Automatic Film Applicator Rxg-00/200 is a device suitable for the production of laboratory cataplasm Spreaders and small quantities of products. It is designed by roller coating to uniformly mix the gel Spreader on the non-woven fabric and compound it with the film to form a long strip. The thickness of the Spreader Film can be controlled by adjusting the gap.
Features
1. Suitable for Laboratory Spreader and Small Batch Production.
2. Spreader uniform with roller coating design.
3. Equipped with release paper and non-woven fabric unwinding device, and a simple tensioning device to adjust the release speed.
4. Spreader device comprises an anti-skid drive roller by surface preparation, Spreader Film thickness adjusting device and Spreader width adjusting device.
5. Adopt gear and synchronous belt drive, equipped with a dedicated stepless motor (with a power of about 120w).
6. The main contact part is made of 304 stainless steel.
7. coating speed 0~ 5m/min stepless adjustment, Spreader Film thickness range of 0.5~ 4mm.
Principle
The device drives the transmission system through the motor to drive the release paper and the non-woven fabric from the unwinding device. The mixed gel is Spreader on the non-woven fabric, and the thickness of the Spreader Film is controlled by adjusting the gap between the release paper and the non-woven fabric drive roller. The non-woven fabric after Spreader is compounded with the rolled film to finally obtain a long strip-shaped finished product.
Applications
Laboratory Cataplasm Spreader, Small Product Production
Steps
1. Prepare a well-mixed gel, non-woven fabric, and film coil.
2. Install the release paper and non-woven fabric on the unwinding device respectively, and adjust the tensioning device to set the appropriate discharge speed.
3. According to requirements, use the Spreader width adjustment device to set the distance between the baffles at both ends of the roller to determine the Spreader width (recommended < 140mm).
4. According to the target Film thickness, use the Spreader Film thickness adjustment device to adjust the gap between the release roll and the non-woven roll (range 0.5~ 4mm).
5. Start the equipment and set the appropriate coating speed (0~ 5m/min) through the stepless speed regulating motor.
6. Spreader and compound operations are performed to obtain a long finished product.
7. After the operation is completed, turn off the equipment and perform cleaning and maintenance.
Notice
• Power frequency is 220V/50Hz before operation.
When adjusting the width of the Spreader, it is recommended not to exceed 140mm.
When adjusting Spreader Film thickness, please pay attention to operating within the range of 0.5~ 4mm.
• When the equipment is running, please pay attention to the unwinding tension state and the uniformity of the Spreader.
• When cleaning, please focus on cleaning 304 stainless steel parts that are in direct contact with the medicine.
• Non-professionals should not disassemble or adjust the transmission system.
