Overview
Lugong ST-408LC humidity chamber is mainly used to simulate the severe high temperature, low temperature or heat and humidity environment that may be encountered in the transportation, storage and use of electronic Instruments, new materials, electricians, vehicles, metals, electronic products, aerospace materials, etc., inspection materials, accessories or instruments. High temperature resistance, cold resistance, moisture resistance performance and possible damage life reduction.
Features
1. The box adopts SUS304 #stainless steel inner box and Cold rolled steel plate paint outer box
2. Equipped with explosion-proof door handles and double-decked vacuum-reinforced Glass observation windows
3. The insulation system uses ultra-fine fiberglass filling and refined silicone rubber sealing
4. Using Japanese Panasonic Compressor and American DuPont environmental protection refrigerant
5. Temperature and Humidity Control Using P.I.D + S.S.R System Co-channel Coordinated Control
6. Heating with nickel-chromium alloy high-speed heating wire
7. Equipped with precision LCD programmable temperature controller
8. Safety protection system
Principle
The equipment works together through the refrigeration system, heating and humidification system and Control system, and adopts the thermal equilibrate temperature control method and P.I.D + S.S.R control technology to accurately simulate environmental conditions such as high temperature, low temperature, heat and humidity, and realize the environmental adaptability test of materials, accessories or instruments.
Applications
Electronic Instruments, New Materials, Electrical, Vehicles, Metals, Electronics, Aerospace Materials
Standards
GB2423.1-2008/IEC6008-2-1-2007、GB/T 2423.2-2008、GJB150.3A－2009、GJB150.4A－2009、GB2423.22-2008、GBT 2424.5-2006、GB/T 10589-2008、GB/T2423.3-2008(IEC68-2-3)
Steps
1. Move the device to the designated position and fix the casters
2. Connect the power supply and water supply system
3. Set test parameters through Touchscreen
4. Place the sample and adjust the sample holder spacing
5. Select the program mode or the fixed value mode to run
6. Monitor the test process through the observation window
7. Process the data after the test is completed
Notice
• The load-bearing capacity of the sample should be evenly distributed, and each sample holder should not exceed 25kg.
• Make sure the equipment is well grounded before use
• Regularly check the refrigerant and water supply system
• Do not open the door frequently during the operation of the equipment
• When a fault alarm occurs, it should be stopped immediately for inspection
• Keep the test hole sealing intact
• Regularly clean observation windows and internal cabinets
