Overview
Lugong ST-1000LD humidity chamber is mainly used to simulate the severe high temperature, low temperature or heat and humidity environment that may be encountered during transportation, storage and use of electronic Instruments, new materials, electricians, vehicles, metals, electronic products, aerospace materials, etc. The equipment can inspect the weathering performance and possible damage life of materials, accessories or instruments in high temperature, low temperature, heat and humidity alternating environments.
Features
1. The box adopts SUS304 #stainless steel inner box and Cold rolled steel plate paint outer box, equipped with explosion-proof door handle and ultra-fine fiberglass insulation system
2. Using Japanese Panasonic Compressor and American DuPont environmental protection refrigerant, equipped with binary low temperature circuit system
3. Temperature and Humidity control adopts P.I.D + S.S.R system co-channel coordination control, with automatic calculation function
4. The heating adopts nickel-chromium alloy high-speed heating wire, and the humidification adopts stainless steel tube with built-in nickel-chromium alloy high-speed heating wire
5. Equipped with precision liquid crystal display programmable temperature controller, supports multiple sets of multi-stage programming operations
6. With USB data transfer interface, can connect to printer or 232 Communication interface
7. Equipped with a complete protection system, including multiple protections such as over-temperature, fan overheating, and underphase/inverse
Principle
Temperature Humidity is controlled by P.I.D + S.S.R system, and thermal equilibrate is used to adjust temperature. The refrigeration system adopts Panasonic Compressor and binary low temperature circuit design, the heating system uses nickel-chromium alloy heating wire, and the humidification system adopts isolated humidification. Control system monitors temperature Humidity changes in real time through PT100 Platinum Resistance Sensor, and corrects the conditions immediately to ensure accurate and stable thermal insulation Humidity control.
Applications
Electronic Instruments, New Materials, Electrical, Vehicles, Metals, Electronics, Aerospace Materials
Standards
GB2423.1-2008/IEC6008-2-1-2007、GB/T 2423.2-2008、GJB150.3A－2009、GJB150.4A－2009、GB2423.22-2008、GBT 2424.5-2006、GB/T 10589-2008、GB/T2423.3-2008(IEC68-2-3)
Steps
1. Move the machine to the designated position through the bottom PU movable wheel and fix the casters
2. Adjust the spacing of the sample holders and distribute the samples evenly according to the load-bearing capacity of 25kg
3. Set the test parameters through the touch setting interface
4. Select the program mode or the fixed value mode to run the test
5. Monitor the test process through the observation window
6. After the test, export the data through the USB interface
Notice
• Samples should be evenly distributed on the sample rack according to the load-bearing capacity of 25kg
• Before use, confirm that the bottom casters of the equipment are fixed
• The test process can be monitored by double-decked vacuum reinforced Glass observation window
• The equipment has multiple protection functions, and it will automatically shut down after a fault alarm
• Data transfer and storage via USB interface
Equipment is equipped with an automatic water replenishment device to ensure the normal operation of the water supply system
