Overview
The Kedian MC-3000A platings thickness gauge is a measuring instrument using the principle of magnetic Induction, which can facilitate the nondestructive measurement of the thickness of nonmagnetic platings on ferromagnetic materials, such as zinc, copper, chromium or paints on steel surfaces, enamel, frp, rubber, spray, asphalt and other coatings. The instrument uses a unique deviation automatic tracking technology, Probe is processed according to German process standards, and uses new alloy materials to improve the accuracy of measurement and the service life of Probe.
Features
1. Measurement mode: Normal mode, MIN Minimum mode, Statistical mode.
2. Measurement mode, can set the difference and the upper and lower limit alarm.
3. Powerful data management: single, grouped or all stored data can be deleted, a total of 6 groups, each group can store 100 measurement points, and can be viewed in groups.
4. Calibration methods are diverse: support zero-point calibrating, two-point calibrating and system calibrating.
5. Flexible system settings: shutdown mode, backlight switch, and factory reset can be set.
6. With printing function: can print stored values or statistical values.
7. Adopt 6-key waterproof and oil-proof keyboard, 3-digit LCD digital display screen, easy to operate.
8. The power supply is 2 AA batteries, which can be used continuously for up to 200 hours, and there is a battery voltage prompt.
Principle
The MC-3000A coating platings thickness gauge works on the principle of magnetic Induction. When the Probe is close to the ferromagnetic material under test, the instrument accurately calculates the thickness of the coating by measuring the Magnetic flux change caused by the presence of nonmagnetic coatings between the Probe and the base material.
Applications
Steel surface galvanizing, copper plating, chrome coating measurement, paints coating measurement, enamel coating measurement, frp coating measurement, rubber coating measurement, spray coating measurement, asphalt coating measurement
Steps
1. According to the measurement requirements, select the normal mode, MIN Minimum mode or statistical mode.
2. If you need to monitor, enter the Monitoring Measurement mode and set the difference and upper and lower limit alarm values.
3. Perform zero point calibrating, two point calibrating or system calibrating to ensure measurement accuracy.
4. Place Probe vertically on the surface of the coating to be tested for measurement.
5. After measurement, the data can be stored manually, and the data will be saved in groups.
6. You can view, delete or print the stored measurement data and statistical values (MAX Maximum, MIN Minimum, Average) through the instrument.
7. After use, it can be automatically or manually shut down according to the settings.
Notice
• This instrument is suitable for measurement of nonmagnetic Coating thickness on ferromagnetic materials.
• Make sure the instrument is properly calibrated before measurement.
• Probe should be vertically aligned and close to the measured surface for measurement.
• Ambient Temperature 0~ 40 ℃, relative humidity ≤ 90% RH, do not use in environments beyond this range.
• Please use the specified 2 AA batteries and pay attention to the battery level prompt.
• Although the keyboard has waterproof and oil-proof function, it is still necessary to avoid long-term immersion or contact with corrosive liquids.
• The stored data can be deleted manually, please confirm before operation.
• The instrument weight is 360g, Dimension 146 * 81 * 30mm, please keep it properly to avoid falling or impact.
