Overview
The AN AM200S-P electric Stirrer is a compact series motor driven laboratory equipment suitable for mixing low to medium and high viscosity liquids. The machine is composed of a drive motor, a speed control controller and a torque increasing mechanism. The body is made of good engineering plastic and die-cast aluminum alloy, and the running state is stable.
Features
1. Adopt high-quality engineering plastics and die-cast aluminum alloy bodies for stable operation.
2. A variable speed booster mechanism is applied at the output end to double the output torque.
3. Stir speed is controlled by the microprocessor, which can instantly and effectively compensate for the speed change caused by load change and Power frequency fluctuation, and the constant speed is reliable.
4. Built-in soft start and automatic overload protection ensure the safety of continuous operation at full load for a long time.
5. Stir speed stepless adjustment, to meet the experimental Stir speed correction at any time.
Principle
The electric Stirrer is driven by a series-excited micro-motor, and the speed is precisely adjusted and stabilized through a speed control system controlled by a microprocessor. The output end is equipped with a torque increasing mechanism, which amplifies the torque output by the motor to cope with the needs of different viscosity liquids Stir. The system has a dynamic detection function, which can compensate for load and voltage changes in real time to ensure constant speed operation.
Applications
Laboratory Liquid Stirring
Standards
Protection Rating: IP 40
Steps
Select and install the appropriate Impeller according to Stir requirements (clamping range 2~ 13mm).
Connect the power supply (AC 100~ 240V, 50/60Hz).
3. Set the required speed (30~ 2000rpm, stepless speed regulation) and timing time (1~ 6000min) through the combined control knob.
4. Start the device with a built-in soft start function to make the Stir start smoothly.
5. Monitor the operating status such as speed through the LCD display.
6. After running, turn off the power and remove the Impeller for cleaning.
Notice
• Power frequency within the range of AC 100~ 240V.
• Impeller installation needs to be firm, and the clamping range should not exceed 2~ 13mm.
• The maximum processing capacity of the equipment is 30L, and the maximum viscosity of the liquid shall not exceed 100000mPa.s.
• Ambient Temperature shall not exceed 40 ° C and relative humidity shall not exceed 80%.
Equipment has overload protection function, but do not overload for a long time.
• Be sure to disconnect the power supply before cleaning and maintenance.
Do not use in environments that are outside the specified parameters or where the Protection Rating (IP 40) does not apply.
