Overview
The KOSON KS-50T (φ 20-40) anchor is an anchor set specially designed to be used with the KS-50T anchor pull instrument. The set includes seven different specifications of anchors: φ 20, φ 22, φ 25, φ 28, φ 32, φ 36, and φ 40 to meet the testing needs of anchors of different diameters.
Features
1. Specially designed for KS-50T bolt puller, with good compatibility.
2. The set includes seven different specifications (Should 20, Should 22, Should 25, Should 28, Should 32, Should 36, Should 40), covering a wide range.
3. Suitable for bolt pull tests of various diameters.
Principle
As a key accessory of the KS-50T bolt pullout instrument, the anchor set clamps the bolt of corresponding diameter through its anchors of different specifications, and transmits the pulling force generated by the pullout instrument to the bolt effectively and stably, thus completing the pulling force test of the bolt.
Applications
Anchor drawing force test
Steps
1. According to the diameter of the bolt to be tested, select the anchor of the corresponding specification from the set.
2. Install the selected anchors correctly on the KS-50T bolt puller.
3. Use the drawing instrument installed with the anchor to test the pulling force of the anchor.
Notice
• Before use, please confirm that the anchor specification matches the diameter of the bolt to be tested.
• Make sure that the anchor and KS-50T puller are firmly installed to prevent slippage during the test.
• Regularly check the abrasion of the anchor, and replace it in time if it is damaged.
• Please operate in strict accordance with the operating procedures of the matching KS-50T bolt puller.
