Overview
The KOSON KS-60T (φ 20-40) anchor is an anchor set specially designed to be used with the KS-50T anchor puller. The set includes seven different specifications of anchors: φ 20, φ 22, φ 25, φ 28, φ 32, φ 36, and φ 40.
Features
1. Specially designed for KS-50T bolt puller, with good compatibility.
2. The set includes seven different specifications (Should 20, Should 22, Should 25, Should 28, Should 32, Should 36, Should 40), covering a wide range.
Principle
As a key component of the KS-50T bolt drawing instrument, the anchor is used to clamp and fix bolts of different diameters in the drawing test to ensure that the pulling force can be effectively and accurately transmitted to the tested bolt, thus completing the anchoring performance test.
Applications
Bolt drawing test, engineering inspection
Steps
1. According to the diameter of the bolt to be tested, select the anchor of the corresponding specification from the set.
2. Install the selected anchors correctly on the KS-50T bolt puller.
3. Use an anchor to clamp and fix the measured bolt.
4. Start the drawing instrument for testing, and remove the anchors after the test is completed.
Notice
• Before use, please confirm that the anchor specification matches the diameter of the bolt to be tested.
• Make sure the anchor is firmly installed on the puller to prevent loosening during the test.
• Regularly check the abrasion of the anchor, and replace it in time if it is damaged.
• Please operate in strict accordance with the operating procedures of the matching KS-50T bolt puller.
