Overview
The KOSON KS-100T (φ 25-40) anchor is a matching anchor set specially designed for the KS-100T anchor puller. The set includes five different specifications of anchors: φ 25, φ 28, φ 32, φ 36, and φ 40.
Features
1. Specially designed for KS-100T bolt drawing instrument, with good compatibility.
2. The set includes five commonly used specifications (φ 25, φ 28, φ 32, φ 36, φ 40), which are suitable for a wide range of applications.
Principle
As a key connecting part of the KS-100T bolt drawing instrument, the anchor is closely matched with the anchor rod of a specific diameter through its internal structure, and the tension generated by the drawing instrument is effectively and stably transmitted to the bolt to be tested, thus completing the drawing test.
Applications
Bolt mass inspection, construction engineering, geotechnical engineering, tunnel engineering, slope support engineering
Steps
1. According to the diameter of the bolt to be tested, select the anchor of the corresponding specification.
2. Install the selected anchors correctly on the KS-100T bolt puller.
3. Reliably connect the anchor to the end of the bolt to be tested.
4. Carry out the drawing test according to the operating procedures of the KS-100T bolt drawing instrument.
Notice
• Before use, please confirm that the anchor specification exactly matches the diameter of the bolt to be tested.
• Ensure that the connection between the anchor and the drawing instrument and bolt is firm and reliable.
• Do not use anchors beyond specifications.
• Regularly check the abrasion of the anchor, and replace it in time if it is damaged.
