The gear pair and crank lifting mechanism are used to achieve accurate bending, the first bending angle is less than 45 °, the flattening mechanism Travel ≥ 10mm, which can test 0.5-2 mm thickness plates and support OT to T bend test.
A bending angle is less than 45 degrees, can test 0.5~ 1.0mm Film thickness sample, flattening mechanism stroke is not less than 10mm, using crank lifting mechanism to achieve T-shaped bending test.
The test bending angle is less than 45 degrees, suitable for steel plate thickness 0.5~ 1.0mm and Aluminum Panel thickness 0.5~ 2.0mm. The gear pair and crank lifting mechanism are used to achieve T-shaped bending, which is easy to operate.
Support 0.1-1 steel plate and 0.1-2 Aluminum Panel test, can complete 0T to 1T multi-stage bending, equipped with pliers pressing device and tape adhesion inspection function, to meet the standard bending test process.
The instrument is equipped with eight kinds of diaMeter stainless steel cylindrical mandrel, which adopts the form of hinge connection bending, which can accurately test the bending deformation of coatings under different diaMeters to ensure the test Reliability.
Equipped with 2 to 12mm eight diaMeter stainless steel cylindrical mandrel, in the form of hinged bending, in line with GB6742 standard, suitable for Coating bending performance testing.
With +/- 0.1% accuracy Sensor and 0.01mN resolution, it supports 1-92 ° bending angle adjustment and 0.5-50 °/sec angular speed control, with self-Adjustment and three independently adjustable test angles, suitable for 0.01-5 thickness materials.
Can test 4 shoes at the same time, bending angle 0 °~ 90 ° adjustable, Test speed 0~ 140 times/min, with automatic return and LCD counter function.
It is suitable for low temperature bending resistance test of 32-63mm diaMeter silicon core tube. The sample needs to be kept at -20 ℃ +/- 2 ℃ for 2 hours, and there is no cracking or obvious stress blushing phenomenon after testing.
Maximum load 100KN, suitable for bending testing of various materials, with high load-bearing capacity and Stability, to meet different testing requirements.
With a bending angle of 135 degrees and a folding speed of 175 times per minute, it can apply a test load of 4.91N to 14.72N, and the automatic counting function accurately records the number of breaks, which is suitable for material durability testing.
It can measure three different angles at the same time, the angle range is adjustable from 1-92 °, the Measurement range is 0-10000mN, and it supports a variety of material tests with bending length and thickness 0.01-5 mm. It has automatic reset and self-Adjustment.
The equipment can perform a 45 ° bending test, support 0.5~ 1.0mm plate thickness, equipped with Travel ≥ 10mm flattening mechanism, suitable for accurate testing of coating flexibility.
Using 12 stainless steel shaft Rods with a diaMeter of 2-32mm, the 50mm wide test plate can be tested for 180 ° bending. The coating cracking situation is detected by decreasing the diaMeter of the shaft Rod, and the operation is simple and fast.
Using pure mechanical design, the coating performance is measured by conical mandrel bending test plate, the test plate size is 100mm × 180mm, the thickness is less than or equal to 0.8mm, and the operation is simple and reliable.
