The formed pRoduction process ensures that the film is uniform, the film thickness is 22.9μm, the application width is 300mm, which is suitable for low viscosity glue experiment, and the material is wear-resistant stainless steel to prolong the service life.
Using 470nm wavelength and double-sided LED Illuminant irradiation, equipped with amber filter and 105 * 163mm glue cutting area, accurate fluorescence sample separation operation can be achieved.
Film Film thickness 22.9μm, Spreader width 30cm, wear-resistant stainless steel material, molding process, suitable for low viscosity glue and thermal glue experimental Spreader.
Using double-sided LED Illuminant and 400nm wavelength, equipped with amber filter, the glue cutting area is up to 105 * 163mm, which is convenient for accurate separation of fluorescently labeled nucleic acid protein samples.
Using 365nm wavelength double-sided LED Illuminant, equipped with amber filter, the glue cutting area is up to 105 * 163mm, which can clearly observe the fluorescence and accurately separate the target area.
Using molding process to ensure unbroken wire, film thickness 32.0 μ m, effective application width 300mm, suitable for a variety of Adhesive sample Spreader.
Formed process preparatory 250 micron wet-film, 300mm effective application width, stainless steel material wear-resistant, anti-corrosion and easy to clean, no handle direct hand operation.
Effective application width up to 500mm, UV curing length 1000mm, using Touchscreen control, support 0-5m/min pRoduction speed, with tension control unwinding and adjustable UV UV light intensity 1-30mw/cm ² to ensure uniform curing.
The application width of the equipment can be adjusted to 600mm, the wet film thickness range is 0.005-3mm, the heating temperature of the rubber roller reaches 200 ° C, and it has the function of automatic deviation correction and Laminating to ensure that the Spreader is uniform and efficient.
Accuracy up to +/- 2 microns to ensure experimental accuracy, high Hardness stainless steel material Hardness 50~ 55HRC, corrosion resistance and wear resistance, application width 160mm total length 190mm lengthened design.
Adopting dip coating with double roll extrusion structure, Spreader thickness 0.3-10 mm adjustable, mechanical speed 1.2m/min can be slowly adjusted, built-in glue circulation system to ensure Spreader uniformity.
Application width up to 400mm, pRoduction speed 0-5m/min adjustable, UV light curing area 400 * 1000mm, main peak wavelength 365nm, equipped with tension control unwinding and Touchscreen Operating interface to achieve stable Spreader and rapid curing.
Using slot-die coating method, application width ≤ 500mm, thickness range 10-250μm; equipped with automatic deviation correction and constant tension system, Oven temperature RT +~ 160 ℃, support segmented thermostatic, ensure Spreader accuracy +/- 3 microns.
K-shaped cogging design, large tooth spacing, suitable for high viscosity Coating, wet film thickness of 150 μ m, leveling well, the bottom of the cogging is wider, suitable for large glue viscosity application scenarios.
Four-station independent operation, speed accuracy +/- 1% and range 100-7000rpm, support 5-stage program control and 3000 seconds homogenizing time, equipped with HEPA efficient filtrate to achieve 99.99% purification rate.
