Measured value 500N, suitable for rubber, cable, paper, electrical components, Plastic film and other materials tensile force, destructive force and insertion force test, supporting the Force Gauge test bench.
Measured value 500N, suitable for rubber, cable, paper, electrical components, Plastic film and other materials tensile force, destructive force, insertion force test, supporting Force Gauge test bench.
Measured value 500N, suitable for sheet, block material push-pull and destructive force test, can be used with Force Gauge test stand.
With paint penetration measurement ability, accurate measurement of wall thickness without removing coatings, thickness range 2.5~ 125mm, accuracy +/- 0.03mm, support multi-echo and single-echo mode switching, suitable for detection needs of different surface conditions.
Measured value up to 5000N, suitable for sheet and block material push-pull force and destructive force test, supporting the Force Gauge test bench.
Hand type easy to operate, load 1000g, standard 6B-6H pencil, suitable for film hardness testing, test temperature 23 +/- 2 ℃ and Humidity 50 +/- 5% environment.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Frequency 5.0MHz, support paint layer detection and emission to echo mode, Measurement range 2~ 160mm, suitable for a variety of workpiece thickness measurement.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Measured value 50000N, suitable for tape, leather, paper and other sheet or block material push-pull force and destructive force test, supporting the Force Gauge test bench.
Measured value 500N, suitable for fabric, paper, wool, fiber, leather, rubber and other materials tensile force, destructive force and extension test, dedicated to supporting the Force Gauge test bench.
Set cross-cut adhesion, film thickness and Buchholz Crowd Hardness three test functions in one, cross-cut knife 6 blade spacing 1mm/2mm, Crowd knife load 500 +/- 5g, using the destruction Measurement principle.
The device adopts destructive measurement, resolution +/- 0.001mm, can carry out V-shaped incision, grid cutting and Cedar test, directly observe Coating thickness and Cedar length, support multi-layer film analysis.
In line with ISO2808-1974 standard, the range is 0~ 150μm, the accuracy is not more than 5μm, can measure the wet film thickness and estimate dry-film thickness, suitable for laboratory and pRoduction control.
Measured value 5000N, suitable for the tensile strength and destructive force test of steel wire, iron wire, fishing line, nylon wire rope and various cables with a maximum diaMeter of 6mm, specially designed for Force Gauge test bench.
