Made of carbide steel, the number of teeth is 11, and the tooth spacing is 1mm to ensure accurate and even cross-cutting. The winger design improves cutting effect and durability.
Multi-blade design is equipped with 6 cutter teeth, 1.5mm equal spacing arrangement, suitable for 50~ 125μm film thickness environment testing, to ensure cross-cutting accuracy in line with international standards.
The number of teeth is 11, the spacing is 1mm, and the single-sided simple cutter head design can be used for cross-cutting experiments. Standard two cutter heads are provided for easy operation.
Equipped with 1mm and 2mm cutter head spacing, the number of cutter teeth is 11, which can meet the needs of different paint film thickness testing, easy to operate and in line with international standards.
11 teeth blade design, 1.5mm isometric cutting, equipped with automatic adjustment of the blade holder to ensure pressure Balance, circular cutter with eight incisions, suitable for 50-125μm film thickness environment test.
Tooth pitch of 1mm, 6 teeth design, can accurately draw 25 squares, suitable for 0-60 µm film thickness of strong substrate testing, in line with international standards.
11 tooth cutter design, 2mm pitch, single-sided simple cutter head, can carry out cross-cut experiment, test coating adhesion, in line with a number of international standards.
The number of teeth 6, spacing 3mm, using circumferential multi-faceted cutter surface design, long service life, suitable for film thickness greater than 120 μ m hard substrate test cross-cut.
Made of stainless steel, with 6 precision teeth, the spacing is accurate to 1mm, and the cutting edge is kept sharp to ensure the accuracy and Repeatability of the paint film test.
Adopting ergonomic handshake design, it is lightweight and labor-saving to use; the blade can be quickly replaced, the top width of the blade is less than 0.05mm, and the included angle is 30 ° +/- 1 °, ensuring accurate cutting and long-lasting durability.
The 11-tooth multi-edge cutting knife is used to provide three spacings of 1mm, 2mm and 3mm, which are suitable for different film thickness tests.
The number of teeth is 6 teeth, the spacing is 2mm, and the multi-cutter surface circumference and multi-faceted design is adopted, which has a long service life and is suitable for 60 to 120μm hard substrate samples.
Suitable for metallographic sample cutting, the maximum cutting cross section of 65 * 65mm, spindle Rotation speed 2800rpm, equipped with circulating chilling down system, the surface of the sample after cutting is bright and flat without burns, easy to operate.
Wedge cutting method for direct measurement Coating thickness, equipped with 50 times magnification Microscope can read 1/100 grid accuracy, support multi-layer coating system delamination measurement, weight only 400 grams for on-site operation.
Adopting 6 cutter face circumference multi-face cutter tooth structure, the service life is significantly improved. The cutter tooth spacing is 1mm, which is suitable for the testing requirements of solid substrates with film thickness below 60μm.
