Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
The pressure column and ball joint structure are used to ensure that the test surface is close, the pressure column mass is 250g, the bottom surface diaMeter is Φ 50 +/- 1mm, and it is equipped with 100g to 500g weight, which can simulate the contact performance of coatings under different pressure conditions.
Constant pressure ensures uniform sampling, suitable for a variety of powder material testing, implementation of GB9087-88 and other standards, improve sampling accuracy and conformity.
Equipped with three replaceable spindles, plate spindle measurement 0-22 poise fluid, small ball spindle coverage 0-350 poise range, large ball spindle suitable for 0-75 poise range, to meet the testing needs of different viscosity samples.
It adopts copper ring and steel ball structure, supports 2-3.55 gram steel ball configuration, and accurately determines the softening temperature of the material through the drop distance of 25.4 mm, which is suitable for all kinds of asphalt experiment needs.
Manual pressure control pressure holding operation is simple, electronic pressure holding device reduces mechanical abrasion, pressure range 0~ -90kPa, accuracy +/- 0.1kPa, Organic Glass sealing barrel wall thickness 15mm to enhance compressive strength.
Adopting the principle of rolling timing of the ball by inclined columnar measurement tube, the viscosity range 0.5-1000 00mPa · s, Temperature range -20 ℃ to 120 ℃, Repeatability is better than 0.5%, and the sample sealing measurement has no external interference.
The total weight of steel ball load is 135 +/- 5g, and the test displacement is 30 +/- 1 °, which can automatically detect water permeability and stop counting, and support the simultaneous testing of 1 to 4 test pieces.
Impact performance of the reflective film can be accurately measured by using the principle of free fall of steel ball, steel ball mass 450 +/- 3g, drop 250mm, reasonable structure and simple operation, safe and reliable measurement.
Equipped with three replaceable spindles, covering 0-350 poise wide range, plate spindle accuracy of 0-22 poise, ball spindle supports 0-75 poise and 0-350 poise measurement respectively
Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Driven by servo motor and precision ball screw, the maximum test force is 5000N, Accuracy grade is 0.5, and various test modes such as stretching, compression and bending are supported. Data storage is safe and reliable.
Using high elasticity standard rubber and denim for extrusion test, extrusion pressure 10-120kgf adjustable, Test speed 5-30 times/minute, to meet the requirements of YD/1539-2006 standard.
It can automatically measure the dynamic and Static COF at the same time, and the total error of the force measurement system is less than +/- 2%. It adopts high-precision ball screw drive, stable performance, accurate test and convenient operation.
