The stainless steel pendulum pipe is used to achieve +/- 180 degree swing, equipped with 25 water spray holes and 1-4 rpm adjustable turntable, supporting 50-100kpa water pressure adjustment, and the test water can be recycled without additional waterproof treatment.
Adopt stainless steel pendulum tube to achieve +/- 180 degree swing, equipped with 25 0.4mm nozzles, flow adjustment range 100-1000L/h, support sample holder 1-4 rpm adjustable speed, test water can be recycled.
Test method to achieve tensile compression test, Accuracy grade 1, equipped with 7-inch touch screen display tensile curve, support 50 kinds of fixtures to meet more than 1000 material testing needs.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
Impact accuracy is ensured by double-tube guide structure, the maximum impact energy can reach 320J, the impact height error is controlled within +/- 2mm, and the automatic hammer lifting function is equipped to prevent secondary impact.
Tensile Strength and elongation paraMeters can be detected, test force 500-3000N optional, accuracy +/- 1%, stepless speed 1-500mm/min, suitable for all kinds of paper and Cardboard materials.
Using ball bearing drive and imported motor, Measurement accuracy up to +/- 1%, tensile speed 1-399mm/min adjustable, support sample size flexible adjustment and automatic data statistics function.
The maximum load is 50KN, and the Y-shaped structure design is adopted to ensure stable clamping during testing, which is suitable for tensile performance testing of high-strength materials.
Using ball bearing drive and imported motor, Measurement range 0-30N accuracy of 0.01N, tensile speed 1-399mm/min adjustable, support sample size flexible adjustment and automatic data statistics.
Measurement accuracy +/- 1%, force value resolution 1/200000, with breakpoint ratio 0~ 99% adjustable function, support tensile, tensile shear, tear and other mechanical properties test, with Travel limit and overload protection.
With +/- 180 degree swing tube swing and 1~ 4 rpm adjustable sample holder speed, support 50~ 100kpa water spray pressure and 99 hour time setting, and use stainless steel structure to achieve accurate water test.
Using ball screw and 3 guide shaft drive mechanism, Measurement range 0-1000N, support a variety of sample size and tensile speed adjustment, built-in thermal printer and RS232 Communication interface.
Using S-type Sensor structure, Measurement accuracy of +/- 0.5%, with 10 data storage and automatic calculation functions, support for automatic conversion of N/kgf/lbf units, peak hold and automatic release functions can be freely set time.
Using single chip control technology, the impact height can be preset and automatically positioned, the accuracy is up to +/- 1mm, and the secondary impact can be automatically prevented. The mass range of the hammer body is 0.25-15 kg, and the two test methods of passing method and layer method are supported.
Adopt ball bearing drive and imported motor, with low noise and accurate control; 0~ 1000N force range, adjustable tensile speed from 1 to 399mm/min; support sample size flexible adjustment, with automatic reset and overload protection functions.
