The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
Equipped with three replaceable spindles, plate spindle measurement 0-22 poise fluid, small ball spindle coverage 0-350 poise range, large ball spindle suitable for 0-75 poise range, to meet the testing needs of different viscosity samples.
It adopts copper ring and steel ball structure, supports 2-3.55 gram steel ball configuration, and accurately determines the softening temperature of the material through the drop distance of 25.4 mm, which is suitable for all kinds of asphalt experiment needs.
Adopting the principle of rolling timing of the ball by inclined columnar measurement tube, the viscosity range 0.5-1000 00mPa · s, Temperature range -20 ℃ to 120 ℃, Repeatability is better than 0.5%, and the sample sealing measurement has no external interference.
The total weight of steel ball load is 135 +/- 5g, and the test displacement is 30 +/- 1 °, which can automatically detect water permeability and stop counting, and support the simultaneous testing of 1 to 4 test pieces.
Impact performance of the reflective film can be accurately measured by using the principle of free fall of steel ball, steel ball mass 450 +/- 3g, drop 250mm, reasonable structure and simple operation, safe and reliable measurement.
Equipped with three replaceable spindles, covering 0-350 poise wide range, plate spindle accuracy of 0-22 poise, ball spindle supports 0-75 poise and 0-350 poise measurement respectively
Driven by servo motor and precision ball screw, the maximum test force is 5000N, Accuracy grade is 0.5, and various test modes such as stretching, compression and bending are supported. Data storage is safe and reliable.
Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
It can automatically measure the dynamic and Static COF at the same time, and the total error of the force measurement system is less than +/- 2%. It adopts high-precision ball screw drive, stable performance, accurate test and convenient operation.
Impact energy 11mJ, ball head Hardness up to 1600HV, can measure the minimum thickness of 5mm specimen, suitable for asperity 1.6μm surface, Che diaMeter minimum 0.35mm, to meet the needs of precision hardness testing.
Using ball screw and 3 guide shaft drive mechanism, Measurement range 0-1000N, support a variety of sample size and tensile speed adjustment, built-in thermal printer and RS232 Communication interface.
The Gamma ball impregnation volume replacement method is used to support 0.01-600 g sample range, density accuracy 0.001g/cm ³, adjustable immersion depth and compensation for air buoyancy error, and is suitable for medium and high viscosity fluid testing.
It can automatically measure the dynamic and static COF at the same time, with a force measurement range of 0~ 5N, using high-precision ball screw drive, and equipped with a micro-printer to print multiple sets of results and averages.
Using high-precision ball screw drive, the total error of the force measurement system is less than +/- 2%, and the dynamic and static COF can be automatically measured at the same time. The micro-printer can print multiple sets of results and the average value.
