Using 180 wire metal engraving roller to control the ink film thickness, four pyramidal mesh structure to ensure uniform Spreader, simple operation and easy cleaning, can quickly prepare samples similar to flexographic printing effect.
Automatic ink running stability, ink time and speed can be set, printing pressure 0~ 2mm adjustable, provide low, medium and high three printing speed, each time can be proofed 4 colors to facilitate Color contrast.
Using 400 wire metal anilox roller to control the ink film thickness, flexographic samples can be quickly prepared, easy to use and clean, and the repRoducibility is very similar to that of conventional flexographic printing.
Using 140 wire metal anilox roller to control ink film thickness, flexographic samples can be quickly prepared, easy to use and clean, and high repRoducibility.
The equipment supports 0-2MM pressure adjustment, providing three-speed printing speed (10/15/20 rpm) and uniform ink speed (650/800/1000rpm), which can imprint 2.5mm thick paper and 1mm plastic film to achieve precise uniform ink and stable operation.
Using 100 wire metal anilox roller to control ink film thickness, it can quickly prepare flexographic samples, easy to operate and clean, and good repRoducibility.
Equipped with dual coating methods of wire rod and blade, with an infinitely adjustable coating speed of 1–300 mm/s, wire rod accuracy of ±0.001 mm, blade accuracy of ±0.003 mm, and optional heating and vacuum adsorption functions to meet coating requirements of various thicknesses.
Using 160 * 280mm size, with wire Rod scraping ink to ensure that the film is flat, Glass table is conducive to operation and observation effect.
The thickness of INKS film is precisely controlled by the 200-wire tetragonal pyramid-shaped mesh stainless steel anilox roller, which is easy to clean manually and can quickly prepare samples with highly consistent flexographic printing effects.
Using 180 * 480mm size, with wire Rod or Film Applicator scraping ink, is conducive to the film flat and effective, improve film mass.
Using 15.5cm/min ink wiping speed, equipped with 0.1mm ink coating platen, the test process is precisely controlled by 4.3 inch Touchscreen, which can accurately determine the absorption capacity of the material to the inks vehicle.
Using 180LPI metal anilox roller with 70mm print width, four pyramidal net hole structure to ensure the ink transfer evenly, the handle design in line with ergonomic operation labor-saving.
The printing speed is 0~ 260m/min, the accuracy is less than 0.5, which supports data management and characteristic detection, and can reduce the number of proofing and material waste.
Wet film thickness 22.9 microns, diaMeter 9.52 mm, the forming Rod uses an extrusion process to process continuous grooves, with no wire breakage and easy cleaning; the wire-wound Rod is based on the traditional principle, and there are differences in coating amount.
The printing pressure can be adjusted accurately according to the thickness of the material, and the printing speed can be adjusted. It provides 4 primary color areas and 4 light color areas to ensure that the pattern is clear and tidy.
