Mechatronics design integrated measurement display circuit, manual operation with 20mm/50mm kit, range of 10KN accuracy ≤ +/- 1% F. S, with linear correction and automatic clearing function for a variety of coating platings strength test.
Hydraulic pump is used to uniformly pull off the test column, the speed does not exceed 1MPa/s, the test force is directly displayed by liquid crystal, and the adhesion failure and cohesion failure can be distinguished, with an accuracy of +/- 1% F.S.
Made of stainless steel, the cutter tooth spacing is 1-3mm, the cut mark length is 35mm, and the coating is cut through the grid pattern, and the adhesion effect is evaluated according to the six-level classification, which is suitable for a variety of surface tests.
Hydraulic system measurement coating adhesion, accuracy control within +/- 1% full scale, optional 10mm to 50mm more than the kit size, self-positioning characteristics to ensure smooth rough surface measurement results accurate and reliable.
Hydraulic system measurement coating adhesion, accuracy control within +/- 1% full scale, equipped with multi-function digital display, can automatically calculate different kit size results, self-positioning kit to adapt to various surfaces.
Special design container to ensure measurement conformity, suitable for color scheme, suitable for fine powder particle measurement, effectively avoid the influence of powder tightness and surface Smoothness.
Accessories can detect buttons and other fixed strength, to prevent loosening caused by sharp edge angle damage, the maximum tensile force of 30kg, suitable for clothing toys footwear and other pRoducts adhesion testing.
Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
Hydraulic system measurement coating adhesion, accuracy control within +/- 1%, equipped with self-positioning kit to ensure smooth and rough surface measurement results consistent, optional 10mm to 50mm variety of kit specifications.
Using mechatronics design, equipped with High Accuracy S-type Sensor and screw structure, the range is 0~ 10.000KN, the resolution is up to 0.001KN, 500 pieces of data can be stored and 10 segments of fold line correction can be supported.
Equipped with a 20mm kit and trimmer, the range covers 0-20MPa, and precise positioning is achieved through a transparent sleeve, specially designed for high viscosity coating adhesion testing.
The scribing needle is used to act vertically on the film, the load range is adjustable from 0-2000g, the minimum increment is 50g, and the diaMeter of the steel ball is 1mm, which can accurately determine the minimum weight required to cut the paint film.
Using mechatronics design, range 0~ 10.000KN, resolution 0.001KN, equipped with High Accuracy S-type Sensor and embedded measurement circuit, support peak hold and 500 Data storage, operation is labor-saving and portable.
Hydraulic system for coating detachment measurement, accuracy of +/- 1% full scale, optional 10mm to 50mm spindle and self-positioning function, suitable for smooth rough surfaces without affecting the results.
The adhesive force of the tape is 4.3N/cm, and the principle of cross-cut method is adopted, which is suitable for adhesion testing. The performance is stable and non-degumming, and the test results are accurate and reliable.
