The coaxial cylinder structure is used to achieve accurate viscosity measurement. The sample dosage is only 10-20mL. It is equipped with a removable sample Cup for easy replacement and cleaning. It supports a variety of rotor models to cover a wide range of viscosity.
Using coaxial cylinder structure with a small number of sample adapters, only 7.8-11 ml sample volume, Measurement accuracy +/- 2%, equipped with dual RS232 interfaces to directly connect printers and computers.
Using Hastelloy heating cylinder to avoid high temperature oxidation, dual Sensor temperature control accuracy of +/- 0.5 ℃, support strong corrosion plastic test, with four minutes countdown and RS232 data output function.
The coaxial cylinder structure is used to achieve accurate viscosity measurement under the specified shear rate, the sample volume is only 10-20mL, and the water Bath jacket can keep the temperature uniform and stable. It supports a variety of rotor models covering a wide measurement range.
Digital PID Temperature Control system, temperature control accuracy of +/- 0.2 ℃, the upper and lower heat head independent temperature control, double cylinder synchronous circuit to ensure pressure Balance, heat cover heating uniform, support manual and foot pedal dual operation mode.
Hollow self-resetting hydraulic cylinder design, center aperture 18mm, maximum pull-out force 20kN, compact structure and can be connected by quick connector, suitable for a variety of anchorage inspection.
Hollow cylinder center aperture 85mm, maximum working capacity 800KN, piston Travel 150mm, compact structure easy to carry, manual pump with double pressure Operating Mode.
Hollow self-resetting hydraulic cylinder design, central aperture 27mm, maximum pull-out force 50kN, compact structure and can be connected by quick connector, manual pump versatility.
Hollow cylinder center aperture 65mm, maximum tension 600KN, manual pump high voltage 63Mpa, digital pressure Gauge direct reading tension value, compact structure and easy to carry.
The hollow self-resetting hydraulic cylinder is designed with a central aperture of 18mm and a maximum pulling force of 30kN. It has a compact structure and can be connected by a quick connector. It is suitable for the force value detection of various anchors.
Hollow cylinder center aperture 60mm, maximum tension 500KN, piston Travel 120mm, using quick connector connection, manual pump with high voltage 63Mpa working capacity, suitable for a variety of anchoring physical examination.
The Cobb test method was used to measure the water absorption per unit area, the cross-sectional area of the cylinder was 100 +/- 0.2cm ², and the Basis Weight of the absorbent paper was 200~ 250g/m2, which was suitable for the determination of the surface absorption weight of paper and Cardboard.
Using Nano coating cylinder liner system, the exhaust capacity is 472L/min, the noise is as low as 54dB, the pure oil-free design ensures that the gas is clean, and the automatic operation does not require special personnel to be on duty, which is suitable for high-demand fields.
The center hole of the hollow hydraulic cylinder is 45mm Travel 80mm, the digital pressure Gauge adopts imported sensor accuracy 1% F.S., with peak holding and Data storage functions, and the automatic reset structure is simple and durable.
Hollow cylinder center aperture 75mm, maximum tension 800KN, piston Travel 120mm, compact structure and easy to carry, manual pump with high voltage 63Mpa working capacity, can directly read the tensile value.
