With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
Can test inks multi-directional adhesion at the same time, Friction Frequency 43cpm, Friction Load 2lb/4lb, Abrasion Resistance evaluation by measurement density or Coating thickness reduction, support 0-99999 automatic shutdown.
Using standard sand free fall brushing layer, straight grinding to expose 4mm substrate; can quantify the abrasion per unit thickness of the paint layer of sand volume, the inner diaMeter of the catheter 19mm, sample holder 45 degrees angle fixed.
Using reciprocating motion to simulate transportation abrasion, Friction Frequency 0~ 2.5Hz adjustable, Test Travel 12.7~ 50.8mm, support continuous test 0~ 24 hours, suitable for a variety of can sizes and pressure conditions.
Using 4mm flow hole and chrome-plated Cup structure, the outflow time range is 0-150 seconds, and the correction factor K = 1 +/- 0.03 ensures accurate and reliable viscosity measurement.
Wire-wound design wet film thickness 9.1 μ m, steel wire diaMeter Φ 0.10mm, chrome-plated surface is easy to clean and prolong life, suitable for a variety of substrates, Spreader uniform and flexible.
Scruf Travel 20-300mm adjustable, speed range 1-60cpm, equipped with TFT full color display and intelligent Operating interface, supports manual testing and is compatible with a variety of standard accessories, suitable for coating Abrasion Resistance evaluation.
Adopt reciprocating friction method, Friction Frequency 0~ 2.5Hz, Test Travel 12.7~ 50.8mm, can simulate coating abrasion during transportation, support continuous test 0~ 24 hours.
Measurement range 0~ 1250μm, suitable for LEEB220 and LEEB222 Coating thickness Gauge, Abrasion Resistance is good, suitable for a variety of nonmagnetic Coating thickness detection.
Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
Can set the moving distance 0.5-4 inches, Rotation speed 2-60 times/min and other paraMeters, support wet and dry abrasion test, can test any size or shape sample, ensure test Stability and accuracy.
Equipped with 254nm and 365nm dual-wavelength ultraviolet light sources, it supports thin-layer analysis and paper-layer analysis, can identify fluorescent substances, and is equipped with a 200 * 50mm filter.
With a capacity of 2.5 liters, it adopts a single-layer structure design and is suitable for a variety of Power Dispersers to ensure efficient and stable material handling and easy operation.
The grinding head reciprocates within 110mm Travel, and the Friction Frequency is adjustable from 20 to 60cpm. It cooperates with 1000g weight to test Abrasion Resistance under different pressures, and the digital display counter directly displays the number of frictions.
The width is 11/16inch, and each roll can be tested for about 1800 turns. It needs to be stored at a temperature of 23 +/- 2 ° C and a Humidity of 50 +/- 10% environment to ensure test Stability and Repeatability.
