Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Rotation speed of the ball mill can reach 850rpm, the minimum discharge particle size can reach 0.1μm. It supports dry grinding, wet grinding and other grinding methods, and has adjustable speed rolling and intermittent operation functions.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Rotation speed of the ball mill can reach 1100rpm, the minimum discharge particle size is 0.1μm. It supports dry and wet milling and various material Tanks, and the grinding is uniform and efficient.
Maximum feed size 2mm, minimum discharge particle size 0.1um, support dry grinding wet grinding vacuum grinding and other methods, equipped with a variety of materials ball mill Tank, can control Rotation speed and time to ensure grinding Repeatability.
360 degree tumbling structure combined with planetary disk swirl/spin, maximum Processing capacity 80L, minimum discharge particle size 0.1μm, support dry grinding, wet grinding, vacuum and other grinding methods, equipped with a variety of materials ball mill Tank to adapt to different samples.
Core noise reduction technology is used to reduce operating noise. The rotation ratio of planetary disk and ball mill Tank is 1:2 to pRoduce a strong crushing force. The maximum Processing capacity is 6000ml and the discharge fineness is up to 0.1μm. It supports various grinding methods such as dry and wet grinding.
With 10L Processing capacity and 0.1μm discharge accuracy, four-station design and 580rpm Rotation speed, support wet and dry grinding and vacuum grinding, configuration 600CFM cooling system and a variety of materials ball mill Tank optional, good grinding conformity.
The equipment adopts a combined structure for easy maintenance, and is equipped with a 200CFM heat dissipation system and a low center of gravity design to ensure stable operation. The maximum Processing capacity is 60L, the minimum discharge particle size is 0.1μm. It supports four ball mill Tank stations and various grinding modes.
Equipped with three sets of independent rollers, load accuracy of +/- 5g, rolling speed of 300mm/min, can accurately simulate the bonding effect of materials under different pressure conditions, rubber wheel Hardness Hs80 +/- 5 to ensure test conformity.
Adjustable tilt angle 0~ 40 °, the steel ball meets the standard of GB/T308 grade 40 or above, which is convenient for angle and position adjustment.
Adopt oblique block to adjust the gap, good self-cumbersome and high adjustment accuracy; Roller cylindricity ≤ +/- 2um, Hardness up to HRC62 and hard chrome plating to prevent rust; Electric rolling can be reversed, and the film thickness and speed can be adjusted.
Brushless DC motor, Rotation speed 100rpm, support positive and negative rolling mode, compatible with different size testtube, low noise and maintenance-free operation, suitable for long-term continuous operation.
The linear velocity of blade disk is 10.5 m/s, the volume of material barrel is 1.8 L, and the aggregates are destroyed by strong impact and shearing to achieve high-efficiency dispersion and mixing, which is suitable for liquid material experiments.
Using 1400rpm speed regulation and 1.5 liters effective volume sand grinding basket, rapid dispersion and grinding are achieved through tensile shear and Impact between sand and material, and the operation is simple.
