Measurement range 0-12.7 mm, Graduation up to 0.001mm, using flat probe design to ensure accurate and reliable test data, suitable for all kinds of material thickness detection.
It is designed with a digital thousand-minute differentiator, with a dual unit display of μm and mils, with a range of 0~ 10mm and a Graduation of 1μm, to achieve precise thickness control.
Provide an additional one-year warranty period, which is applicable to Coating thickness Gauge pRoducts. It needs to be purchased simultaneously when purchasing the equipment and is not sold separately.
Using digital High Accuracy dial head, Measurement range 0~ 12mm, Graduation up to 0.01/0 mm, with measurement safety locking mechanism and holding function, easy and reliable operation.
Dedicated to Coating thickness Gauge calibrating, ensure accurate thickness measurement, suitable for F type equipment, improve Reliability.
Measurement range 0-10mm, accuracy ≤ 0.02mm, equipped with a variety of probe diaMeters including Φ 2mm, Φ 5mm, etc., support different pressure settings, simple and reliable structure.
Measurement range 0~ 12.7mm, accuracy ≤ 0.02mm, using digital display reading indexing value 0.01mm, simple structure and reliable mass.
Measurement range 0~ 1250μm, suitable for LEEB220 and LEEB222 Coating thickness Gauge, Abrasion Resistance is good, suitable for a variety of nonmagnetic Coating thickness detection.
Using 5.0MHz Frequency, Measurement range 0.8-300 mm, suitable for flat or large radian surface, pipe measurement lower limit Φ 25 * 1.2mm, support a variety of working conditions detection.
Measurement range 0-20mm, accuracy 0.01mm, contact pressure 20 +/- 0.5kPa, contact surface diaMeter 35.7mm, suitable for a variety of sheet material thickness detection, to ensure high parallelism and Precision.
The three-wheel structure design is adopted, and the center wheel contacts the film directly for reading. The measuring range is 0-500 μm and the indexing is 25 μm. It can perform nondestructive thickness measurement on plane and curved surface.
Hollow cylinder center aperture 65mm, maximum tension 600KN, manual pump high voltage 63Mpa, digital pressure Gauge direct reading tension value, compact structure and easy to carry.
It can cut 32.2cm ² and 64.5cm ² samples, the sampling error is less than 0.5cm ², and the maximum sampling thickness is 15mm, which meets the accurate sampling requirements of Corrugated Board Flat Crush Test.
Measurement range 0-6mm, accuracy of 0.01mm, contact pressure 100 +/- 5kpa, with digital display function and stable parallelism measurement, suitable for a variety of materials Film thickness detection.
Equipped with 6 teeth 2mm pitch stainless steel cutter head, adjustable cutter head angle, suitable for 61-120μm film thickness test, with nylon brush and 2.5x magnifying glass, to meet a variety of international standards.
