The circular track is used to automatically record the film drying process continuously, equipped with 4 kinds of specifications to choose from, the track diaMeter is 100mm, and the measurement error is +/- 0.5%, which can intuitively analyze the stages in drying state.
Equipped with 6 strokes and 305mm Travel, it can automatically record four stages of the drying process continuously, and intuitively display the curing state of the paint film through the straight track, and the measurement error is controlled within +/- 4%.
It can measure drying time from 1 minute to 48 hours, with accuracy up to 10 seconds, and has intelligent recording function to improve the resolution of long drying process, which is suitable for various coating types.
Equipped with 6 Φ 1mm scribing needles and 3 independent carriages, different samples can be tested simultaneously, Travel 300mm, load 11g, and the coating stages in drying can be accurately determined by observing the scratch track.
Equipped with 6 Φ 1mm scribing needles and 11g load, 300mm Travel can be set to 6/12/24 hours track period, and each stage of coating drying can be accurately determined by scratch observation method.
Simultaneous measurement of 6 samples, with three adjustable speeds for 6-12-24 hours, automatic recording of the drying process to ensure the validity and conformity of the measurement process.
The instrument adopts a six-pin design, forms plow marks on the paint film through uniform linear motion, and automatically displays the drying process according to the change of traces. The measurement error is controlled within +/- 4%, and supports three time settings of 6h, 12h and 24h.
Double-sided design can be coated with two pre-order film thicknesses 90 and 150 μm, Spreader width 20mm, suitable for Automatic Film Applicator and Drying Time Recorder, in accordance with ASTM D 823 standard.
The equipment uses 200 +/- 0.2g weight, sample size 50 * 120 * (0.2~ 0.3) mm, can accurately determine the surface and actual drying time, in line with national standards.
The four-pin design is equipped with four sizes of scribing needles, which can automatically draw a circular track with a diaMeter of 100mm, support three cycle modes of 6/12/24 hours, and the measurement error is controlled within +/- 0.5%.
Temperature control accuracy of +/- 1 ℃, Temperature Uniformity +/- 2 ℃, with overheating alarm and timing function, low noise hot air circulation system to ensure uniform drying, optional RS-485 interface connection recorder.
The tire size of the instrument is Φ 241 +/- 6mm, weight 15.8 +/- 0.2kg, dedicated to marking Coating drying time test, easy to operate, accurate and reliable results.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
Using 200 +/- 0.2 g weight and 1 square centiMeter bottom area design, the drying process of the paint film was accurately determined by the cotton ball method to distinguish between surface drying and actual stages in drying.
Double station design can process two samples at the same time, Vacuum Level up to -0.098MPa, drying time only 4-6 minutes, suitable for rapid drying of wet paper samples with a diaMeter of no more than 200mm.
