Overview
The SX2-4-10N integrated box type resistance furnace is a cycle-operated heater of the JINGQI brand with an integrated programmed temperature control design. The product is used in coal, power, chemical, building materials, metallurgy, R & D institutions and Universities & colleges laboratories for sintering, heating and heat treatment applications.
Features
1. Furnace shell using cold plate by phosphoric acid film salt treatment after high temperature spray, Color for computer gray, durable and beautiful
2. Furnace with high aluminum liner, good wear resistance, 4-sided heating design
3. The thermal insulation system adopts thermal insulation bricks and thermal insulation cotton, which has good thermal insulation effect
4. Temperature control system adopts PID adjustment, display accuracy 1 ℃
5. Built-in secondary over-temperature protection device, with over-temperature alarm and over-temperature interruption function
6. Support 30 program settings, full scale programmable settings, automatic control of temperature rise thermostatic
7. Adopt high-quality electrical components such as brand contactors, cooling fans and solid-state relays
Principle
The resistance furnace is heated by a high temperature resistance wire, and a K-indexed nickel-chromium-nickel-silicon Thermocouple is used for temperature measurement. The control system realizes precise temperature control through PID adjustment. The Thermocouple enters the temperature measurement from the top of the furnace body, and the heating wire terminal is located below the back of the furnace body. The controller is located below the furnace body and is connected to the furnace body through compensation wires to automatically control the thermostatic process of heating up.
Applications
Coal, Electric Power, Chemical, Building Materials, Metallurgy, R & D institutions, Universities & colleges
Steps
1. Connect the power supply and ensure that the voltage is 220V, 50Hz.
2. Set the required temperature program through the controller, and support 30-segment program settings
3. Set Timer Range 0~ 9999min
4. Start the equipment, the system automatically controls the thermostatic process
5. Turn off the device according to the specified procedures after use
Notice
• The maximum temperature of the equipment is 1000 ℃, Temperature range is 100~ 1000 ℃
• The heating rate should be controlled at ≤ 10 ° C/min
• Note that the weight of the equipment is about 80KG, be careful when handling
• Check whether the over-temperature protection device is normal before use
• Power frequency meets 220V, 50Hz requirements
• Regularly check the status of heating elements and terminals
• Pay attention to ventilating heat during equipment operation
