Overview
RONGHUA INSTRUMENT DNP-9272-1A electric thermostatic incubator is a vertical structure equipment. The box and outer door are made of high-quality steel plate surface lame plating, and the inner door is tempered Glass for easy observation. The studio is made of stainless steel plate, the shelf can be moved to adjust the height, and it is equipped with silicone rubber sealing ring to ensure sealing. The box is equipped with flat heater, low noise fan and ultra-fine glass cotton insulation layer. The temperature control system has digital display, temperature protection and tracking alarm functions.
Features
1. Vertical structure, the box and the outer door are made of high-quality steel plate surface lame plating, and the inner door is tempered Glass, which can clearly observe the foster items without opening the door
2. The studio is made of stainless steel, the shelf can be moved and the height can be adjusted arbitrarily
3. There is a silicone rubber sealing ring between the studio and the inner door to ensure good sealing
4. Equipped with three flat panel heaters and low-noise fans to ensure temperature uniformity in the box
5. The box is filled with ultra-fine Glass cotton insulation material
6. Temperature Controller with High Accuracy, Digital Display, Temperature Protection and Tracking Alarm
7. Temperature control accuracy up to 0.1 ℃, Temperature Fluctuation +/- 0.5 ℃
Principle
The electric thermostatic incubator provides heat through three flat panel heaters installed on the left, right and bottom of the outer wall of the studio. The low-noise small fan at the top blows the breeze to promote air circulation in the box and ensure uniform temperature distribution. The thermostatic incubator precisely monitors and adjusts the temperature in the box to achieve thermostatic control.
Applications
**, biology, agriculture, scientific research
Steps
1. Turn on the power supply and turn on the power switch
2. Set the required temperature through the thermostat
3. Place foster items on the shelf and adjust the shelf height
4. Close the box door and start the equipment running
5. Monitor the foster process through the observation window
6. Turn off the power after use
Notice
• Power frequency 220V 50Hz before use
• Pay attention to the protection device when setting the temperature to avoid exceeding the range setting
• Regularly check the integrity of the sealing ring to ensure the sealing of the studio
• Avoid using corrosive cleaners when cleaning
Do not open the door frequently during the operation of the equipment, so as not to affect the temperature stability
• Please disconnect the power supply when not in use for a long time
