Overview
DADI 101-0 electric thermostatic blower drying oven has a maximum operating temperature of 300 ° C, suitable for baking, drying, heat treatment and other heating. The product structure is precise, the temperature control is sensitive and accurate, and it is easy to operate. It can be used in industry, laboratory or scientific research units. Operating temperature can be raised from room temperature to the highest temperature, which can be set arbitrarily within this range. After setting, the temperature control system can be automatically thermostatic, and the working room is equipped with a blower, which can promote air mechanical circulation.
Features
1. Use galvanized iron liner.
2. Equipped with double-decked large window tempered Glass observation door, you can observe the indoor situation without opening the door.
3. Using microcomputer intelligent temperature controller, Temperature range (50-300 ℃), Heating power adjustable, thyristor output.
4. With over-temperature alarm safety device.
Temperature control is sensitive and accurate, Temperature Fluctuation is +/- 1 ℃, uniformity ≤ +/- 2.5%.
6. The control panel is easy to operate and the electrical equipment is centralized.
Principle
The drying oven is heated by an electric heater, and the intelligent temperature controller automatically adjusts the temperature according to the feedback of the temperature sensor to realize thermostatic control. A blower is installed in the working room, which can promote the mechanical circulation of the air and make the temperature in the box more uniform.
Applications
Baking, drying, heat treatment, industrial, laboratory, scientific research units
Standards
JB/T5520-91、JB/Z339-89
Steps
1. Place the equipment in a suitable position to ensure that the power supply voltage matches the rated Operating voltage (220V 50Hz).
2. Open the box door and place the test product on the shelf. Note that the average load does not exceed 45KG/M ². Do not overload and overload, and do not place items on the heat dissipation plate.
3. Close the box door and set the required Operating temperature through the microcomputer intelligent temperature controller.
4. Start the device, the temperature control system will automatically heat and thermostatic at the set value.
5. Internal conditions can be observed through double-decked Glass Doors during work.
6. After the work is completed, turn off the power supply and wait until the temperature in the box drops to a safe range before removing the sample.
Notice
• This box is non-explosion-proof, and it is strictly forbidden to put flammable volatile items into the drying oven to avoid explosion.
• The average load of the sample shelf is 45KG/M ². Do not place the sample too tightly and overloaded. At the same time, the sample and Miscellaneous things cannot be placed on the heat dissipation plate to avoid affecting the convection of hot air.
• When using this box, the power supply voltage must match the rated Operating voltage of this box, otherwise it may cause damage to the electronic instruments in the box.
• Do not disassemble the parts arbitrarily, so as not to damage the electrical wiring in the box.
If the box malfunctions, it should be repaired by an electrician who is familiar with electronic equipment.
