Overview
TAISITE MFLC-16/16T ceramic muffle furnace is a high temperature experimental heater with a maximum operating temperature of 1600 ° C. It adopts an integrated lightweight and compact design, the furnace volume is 16L, the Heating power is 15KW, the silicon molybdenum rod is used as the heating element, and it is equipped with a High Accuracy microcomputer temperature control system, and the temperature control accuracy can reach +/- 1 ° C.
Features
1. Integrated design, lightweight and compact structure.
2. Vacuum forming polycrystalline mullite fiber furnace, good thermal insulation effect.
3. Parallel side open furnace door design keeps the hot end away from the operator.
4. Equipped with safety functions such as door opening and power failure, reset delay, etc.
5. Double shell air insulation, low surface temperature.
6. An exhaust device is provided to facilitate sample ashing.
7. High Accuracy Microcomputer Temperature Controller Combined with S-Type Thermocouple Precision Sensor, Temperature Accuracy.
8. Equipped with a 7-inch color Touchscreen, you can set parameters by tapping your finger.
9. With correction function, gating function, real-time Linear dispersion recording, U disk data export and other additional functions.
10. Multiple safety designs, including over-lift alarm, menu lock, over-lift prevention, door opening and power failure, reset delay, and over-current and leakage protection switch.
Principle
The muffle furnace adopts the principle of resistance heating, which is generated by the heating element of silicon molybdenum rod. The furnace is made of polycrystalline mullite fiber material, which has good thermal insulation performance. The temperature control is completed by the microcomputer PID controller. The temperature in the furnace is monitored in real time through the S-type Thermocouple, and the signal is fed back to the controller. The controller realizes accurate temperature control and program operation by adjusting the Power output of the heating element.
Applications
Material sintering, ashing experiment, high temperature heat treatment, ceramic processing, laboratory analysis
Standards
The data did not mention specific compliance criteria.
Steps
1. Connect the AC380V power supply.
2. Set temperature, program or timing parameters through a 7-inch color Touchscreen.
3. Start running, and the device starts to heat up according to the set program.
4. During the experiment, the real-time temperature Linear dispersion can be observed through the screen.
5. After the experiment, the equipment is cooled down or naturally cooled down according to the procedure.
6. Experimental data can be exported through a USB flash drive.
7. Turn off the power.
Notice
• The device needs to use AC380V power supply, please ensure that the power supply meets the requirements.
• When opening the door, the device will automatically power off. There is a delay in repowering after closing the furnace door. Please pay attention to safety.
• The temperature on the surface of the furnace body and near the furnace door may still be high during high temperature operation. Wear protective equipment during operation to avoid burns.
• Do not heat flammable, explosive or toxic gases in the furnace.
• When using the exhaust hole, please ensure smooth exhaust and pay attention to high temperature exhaust.
• Regularly check whether safety devices such as overcurrent and leakage protection switches are normal.
• Device weight is large (gross weight 195kg), so pay attention to safety when moving and installing.
• Please refer to the detailed manual when setting the program or operating the function.
