Overview
This machine is AISRY brand ASR-5618B mobile phone micro-Drop Tester, which is suitable for mobile phones, telephone handsets, walkie-talkies, MP3, CD, electronic dictionaries and other small electronic consumer products for sexual repeability drop test.
Features
1. The number of times can be set to automatically stop.
2. The drop surface adopts 12mm thick Aluminum Panel, and the baffle at the drop is reset.
3. Using Japan's Shinano motor as the driving source, durable use.
4. Adopting pneumatic components and autocratic Control mode, the test speed is fast and the conformity is good.
5. Adopt display-controlled LCD touch control panel and PLC programmable controller for action programming and counting at the same time.
6. Two mobile phones can be tested simultaneously, with a test load of 2kg.
Principle
The motor drives the upper clamp (air finger) down to clamp the phone and then rise, releasing the air finger to make the phone fall freely. Then the double-acting cylinder extends to push the phone back to a position that can be clamped by the upper clamp. The motor drives the upper clamp down to clamp the phone and rise again. After releasing, the phone falls freely again. This process is repeated until the set number of times is reached.
Applications
Mobile phone, telephone handset, walkie-talkie, MP3, CD, electronic dictionary
Steps
1. Place the product to be tested in the drop position.
2. Set the required number of tests through the touchscreen.
3. Start the device, and the device will automatically perform a clip, lift, drop, and reset cycle.
4. When the number of drops reaches the set value, the device automatically stops testing.
Notice
* The air source pressure should be ≥ 0.5MPa.
The power supply is AC 220V or specified voltage.
* The weight of the equipment is about 40kg, please pay attention to the safety of handling and placement.
The drop height adjustment range is 60 to 150mm, and the test speed range is 6 to 20 times/minute. Please set it reasonably according to the test requirements.
* Please ensure that the weight of the product to be tested does not exceed the test load limit of 2kg.
