Overview
The OSP-07/400 coating rod is an Applicator rod developed using the formed process, which is characterized by continuous filament, easy cleaning, and high cost performance. The coating rod can provide accurate wet-film preparation of 7 μm and is widely used in automotive coatings, Plastic film, printing and R & D units.
Features
1. Using a formed process to ensure that the film is not broken
2. Easy to clean, easy to use and maintain
3. Cost-effective, economical and practical
4.304 stainless steel material, durable and corrosion resistant
5.7 μm accurate wet-film preparatory, high accuracy
Principle
The coating rod is uniformly Spreader Coating on the surface of the substrate through a formed process to form a precise thickness wet-film. When in use, it is uniformly scraped on the surface of the Spreader by manual operation to achieve accurate wet film thickness control of 7 μm.
Applications
Automotive coatings, Plastic film, printing, R & D units
Steps
1. Spreader Substrate and Coatings
2. Coating evenly on one end of the substrate
3. Hold both ends of the coating rod to contact the substrate at an appropriate angle
4. Scrape forward with even force
5. Clean the coating rod in time after completing the Spreader
Notice
• Make sure the coating rod is clean and drying before use
• Keep the force even when scraping
• Wash in time after use to avoid Coating drying
• Avoid collision and extrusion when storing
• Regularly check whether the surface of the coating rod is flat
