Overview
The CHNSPEC CS-660B Colorimeter uses D/8 illumination geometry and CLEDs Illuminant to ensure measurement speed and accuracy. The instrument has a large LCD screen, based on ergonomic design, simple operation, and pre-positioning plate settings to avoid traditional calibrating procedures. The built-in software is powerful, including a variety of color equations, Standard light sources and industry indicators, and has obtained national first-level metrology authentication. It is cost-effective and suitable for color measurement and quality control in factories, laboratories and other occasions.
Features
1. Adopt international general D/8 (integrating sphere diffuse illumination, 8 ° viewing angle) SCI/SCE compatible lighting observation conditions
2. Provide up to three years of quality assurance in the industry
3. Color analysis software is standard, which supports Color data management and test report generation
4. Each instrument is sent to the trusted department for Measurement verification, and the data Traceability is sent to the National Measurement Institute
Standard light source test conditions and nearly 40 measurement chroma indicators
6, built-in camera view, can clearly observe the measurement area
7. Optional Colorschemer studio to quickly find Color composition and optimize formula
Principle
CHNSPEC CS-660B Colorimeter adopts D/8 illumination geometry, integrating sphere diffuse illumination, 8 ° observation angle, compatible with SCI/SCE measurement. The instrument uses CLEDs full-band equalization LED Illuminant to ensure sufficient Light spectrum distribution in the visible range and avoid the loss of specific bands. Using ETC real-time calibrating technology, the Optical inspection system is equipped with a standard whiteboard, and each test is Automatic calibration. Innovative SCS Optical inspection engine (single grating dual light path splitting system) and automatic Gloss compensation technology ensure measurement Repeatability and accuracy.
Applications
Plastics, paints, printing, food, Spinning & weaving, printing and dyeing
Standards
National level metrology authentication
Steps
1. Turn on the instrument power supply
2. Align the measured area through camera viewing
3. Use pre-positioning plate for measurement and positioning
4, start measurement, the instrument automatically calibrates and tests
5, reading measurement data through the LCD screen
6. Use Color Analysis Software to Manage Data and Generate Reports
Notice
• Avoid operating in high temperature and high humidity environment, operating environment is 0-45 ℃, relative humidity 80% or less (35 ℃)
• Avoid condensation of water vapor during storage, the storage environment is -25~ 55 ° C, and the relative humidity is 80% or lower (at 35 ° C)
• Make sure the tested area is clean before measurement to avoid fouling affecting the accuracy
• Regularly check the battery level to ensure continuous measurement
• Powered by a dedicated DC adapter or a removable lithium battery pack
