Overview
KESIONOTS KS-HD408LA low/high temperature test chamber is an environmental test equipment for high temperature and low temperature Reliability test of industrial products. It is suitable for high temperature, low temperature (alternating) cyclic change conditions of parts and materials of electronic and electrical, automotive and motorcycle, aerospace, marine weapons, colleges and universities, R & D institutions and other related products for performance testing, for product design, improvement, identification and inspection.
Features
1. Temperature range is wide, up to -70 ℃ to 150 ℃.
2. Temperature control accuracy, analytical accuracy of +/- 0.1 ℃, control accuracy +/- 1 ℃.
3. The box is made of excellent material, the outer box is high-grade cold-rolled sheet paint, and the inner box is stainless steel.
4. Equipped with a variety of protection devices, such as no fuse switch, Compressor overload protection, over-temperature protection, etc., safe operation.
5. Optional well-known brand controller (Korean "TEMI" or Japanese "OYO") and Compressor ("Taikang" or German BITZER).
6. Provide standard test holes, viewing windows, box lights and other practical accessories.
Principle
The test chamber uses a cooling system (Air-Cooled/Water-Cooled Compressor) and a heating system to create a set high or low temperature environment in a closed box. Control systems (such as TEMI or OYO controllers) precisely adjust the Power of cooling and heating to achieve precise control, cyclic change and constant maintenance of the temperature in the box, thus simulating the extreme temperature conditions that the product may encounter in actual use.
Applications
Electronics and electricians, automobiles and motorcycles, aerospace, ships and weapons, colleges and universities, R & D institutions
Standards
GB2423.1、GB2423.2、GJB150.3、GJB150.4、IEC、MIL
Steps
1. Place the sample to be tested on the Shelf in the box.
2. Close the door and make sure the sealing is good.
3. Set the required temperature program (e.g. target temperature, lifting rate, holding time, etc.) through the controller.
4. Start the equipment, and the test chamber starts to run according to the set program.
5. During the test, the sample status can be observed through the viewing window.
6. After the test, the equipment is automatically stopped or manually stopped, and the sample is taken out after the temperature in the box returns to a safe range.
Notice
• Equipment should be installed in a well-ventilated location without direct sunlight and away from heat sources.
• Do not use this equipment near flammable, explosive or corrosive substances.
• Sample placement should not block the air duct in the box to ensure smooth air circulation.
• After the low temperature test, if you need to open the box door, wait for the temperature inside the box to rise to close to room temperature to prevent frost or frostbite.
• Regularly check the chilling down system (e.g. Water-Cooled type to ensure that the chilling down water supply is normal) and the effectiveness of various protection devices.
• Be sure to cut off the power supply before wiring or maintenance.
• Power supply voltage specified by the device (220VAC +/- 10% or 380VAC +/- 10%).
