Overview
KESIONOTS KS-HD150LB low/high temperature test chamber is an environmental test equipment for high and low temperature Reliability test of industrial products. It is suitable for inspection of electronic and electrical, automobile and motorcycle, aerospace, ship weapons, universities and R & D institutions and other related products. The performance indicators of parts and materials under high temperature and low temperature (alternating) cycle conditions are widely used in product design, improvement, identification and aging test.
Features
1. Temperature range is wide, up to -60 ℃ to 150 ℃.
2. Temperature control accuracy is high, Fluctuation is only +/- 0.5 ℃.
3. Using high-quality materials, the outer box is high-grade cold-rolled sheet paint, and the inner box is stainless steel.
4. Equipped with a variety of protection devices, such as no fuse switch, Compressor overload protection, over-temperature protection, etc., the operation is safe and reliable.
5. Can be equipped with Korean "TEMI" or Japanese "OYO" brand controller according to needs, as well as "Taikang" or German BITZER Compressor.
6. Provide standard accessories, such as viewing windows, test holes, box lights, Shelf, etc., for easy operation and observation.
Principle
The test chamber creates and precisely controls the test environment from low temperature to high temperature in a closed chamber through a cooling system (Air-Cooled/Water-Cooled Compressor) and a heating system. The controller system receives feedback from the temperature sensor and adjusts the output of the cooling or heating elements, so that the temperature in the working room changes quickly and stably according to the set program to simulate the extreme temperature conditions that the product may encounter in actual use.
Applications
Electronics and electricians, automobiles and motorcycles, aerospace, ships and weapons, colleges and universities, R & D institutions
Standards
GB2423.1、GB2423.2、GJB150.3、GJB150.4、IEC、MIL
Steps
1. Place the sample to be tested on the Shelf in the box.
2. Temperature range, change rate and test time are set by the controller.
3. Close the box door, start the equipment, and the test chamber starts to cool down according to the set procedure.
4. During the test, the sample status can be observed through the viewing window.
5. After the test is completed, the device automatically stops or ends according to the program, and the sample is taken out for analysis.
Notice
• Device power supply needs to match, you can choose 220VAC +/- 10% 50/60Hz or 380VAC +/- 10% 50/60Hz.
• The cooling rate is about 1.0 ° C/min, and a decrease of 5 to 10 ° C per minute is a special selection condition, which needs to be confirmed in advance.
• Please ensure that all protective devices (e.g. fuses, fault warnings) are functioning properly before use.
• Do not open the door frequently when the equipment is running, so as not to affect the temperature accuracy and equipment life.
• Regularly check the running status of the chilled down system (Compressor) to ensure good heat dissipation.
