Overview
OSP-330T L250 Mayer Rods adopts formed process, film Film thickness is 330 microns, Spreader width is 25cm, total length is 25cm, can be scraped together with the matching handle, and is made of wear-resistant stainless steel. It is suitable for samples with low preparatory viscosity and large film thickness in the laboratory. Compared with Film Applicator, it has higher accuracy and is formed and easy to clean.
Features
1. Using a formed process, the film Film thickness is 330 microns
2. Spreader width 25cm, total length 25cm
3. It can be scraped together with the matching handle.
4. Made of wear-resistant stainless steel
5. Higher accuracy than Film Applicators
6. formed design, easy to clean
Principle
The OSP-330T L250 Mayer Rods achieves Spreader through a formed process, and the matching handle is used for scraping operation to form a uniform wet-film coating on the surface of the substrate.
Applications
Samples with low laboratory prepative viscosity and large film thickness
Standards
Material meets 304 stainless steel standard
Steps
1. Prepare samples and substrates
2. Install the Spreader rod matching handle
3. Perform scraping operation
4. Clean in time after finishing the Spreader
Notice
• Suitable for samples with low viscosity and large film thickness
• It should be cleaned in time after use
• The matching handle works better
