Overview
The AMITTARI AA-136V impeller Anemometer is widely used for data collection in boilers, refrigeration, HVAC, ventilated piping, environment monitoring, nautical measurement, as well as data collection in weather forecasting, field operations and fire departments.
Features
1. Measurement unit conversion.
2. With MAX Maximum Hold function.
3. With storage function, it can store 24 sets of data.
4. Sensitivity and accurate measurement, Sensor uses ultra-low friction bearings.
5. Wind speed measurement handle can be separated from the fuselage, convenient measurement.
6. Not only can the wind speed be measured, but also the wind temperature, wave height, wind level and air volume can be measured.
7. You can set the automatic shutdown function by yourself (adjustable from 0 to 9 minutes).
8. Use USB data cable output to communicate with PC.
9. In addition, optional configuration Bluetooth data output selection is provided.
Principle
Wind speed/Flow rate measurement using low friction bearing impeller Sensor, temperature measurement using thermistor Sensor, Sampling rate of about 1 second.
Applications
Boiler, refrigeration, HVAC, ventilated pipeline, environment monitoring, nautical measurement, weather forecast, field operation, fire department
Steps
Install 4 1.5V AAA 7 #batteries.
2. Set the automatic shutdown time (0-9 minutes) as required.
3. Connect the wind speed measurement handle (optional separate use).
4. Select Measurement unit (such as CMM, CFM, wind level, wave height, temperature ℃/F).
5. Perform measurements, data is automatically sampled and stored (up to 24 groups).
6. Use the MAX Maximum hold function to record peaks.
7. Output data through USB data cable or optional Bluetooth communication with PC.
Notice
* Operating Temperature range is -10 ° C to 50 ° C (14 ° F to 122 ° F).
* Operating Humidity up to 80% RH.
Make sure the battery is properly installed and fully charged.
* Sensor uses low friction bearings to avoid severe impact to maintain accuracy.
* The automatic shutdown time is adjustable, and it is recommended to set it according to the usage scenario to avoid accidental shutdown.
