Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Adopt circular embossing method to improve the fit, the proofing speed is adjustable from 0-300rpm, equipped with High Accuracy Servo Motor and quick replacement anilox roller system, support a variety of gray scale customization.
The stator diaMeter is 8mm, the maximum processing viscosity is 500CP, and the maximum linear speed is 8 m2/s. It is suitable for 10~ 60ml Sample Handling and is suitable for HR-6B/10B type homogenizer.
Using irreversible discoloration technology, white turns black after overheating while displaying numbers, Measuring temperature 75 ° C, circular patch design is easy to observe temperature changes.
The stator diaMeter is 10mm, the maximum processing viscosity is 2000CP, and the maximum linear speed is 10 m2/s. It is suitable for HR-6B/10B type homogenizer, and the standard Processing capacity is 30-150ml.
The adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel ≥ 80mm. The integrity of the paint film was evaluated by seven grades, and the operation was simple and conformed to the GB/T1720 standard.
Pressure sensitive adhesive paste firmly, 65 ℃ single point temperature measurement accuracy, irreversible discoloration characteristics can permanently record the overtemperature state, circular design for easy observation, 2x2cm specification suitable for small space installation.
Synchronized processing of 12-bit samples, temperature control accuracy of +/- 1 ℃, circular water Bath heating and independent air path adjustment. Each air needle channel can be switched on and off separately, 316 stainless steel material is corrosion resistant, suitable for a variety of testtube specifications, supports timing and over-temperature alarm functions.
The circular stainless steel liner is used to prevent condensation and dripping, the copper tube bell mouth is designed with good air tightness and low water consumption, and the special high temperature foaming material improves the pressure life. It is equipped with a 16L large-capacity water Tank and an automatic water replenishment system.
The four-pin design is equipped with four sizes of scribing needles, which can automatically draw a circular track with a diaMeter of 100mm, support three cycle modes of 6/12/24 hours, and the measurement error is controlled within +/- 0.5%.
Adopt the circular roller scratch method to evaluate the adhesion grade, describe the adjustable diaMeter of 0-10.5 mm, equipped with four weights to achieve 200-1000g loading, table Travel ≥ 80mm, manual operation is stable and reliable.
Using irreversible discoloration technology, temperature accuracy up to 120 ℃, circular 2x2cm size with Pressure sensitive adhesive firmly pasted, surface protective film to enhance durability, suitable for harsh Ambient Temperature Monitoring.
The circular track is used to automatically record the film drying process continuously, equipped with 4 kinds of specifications to choose from, the track diaMeter is 100mm, and the measurement error is +/- 0.5%, which can intuitively analyze the stages in drying state.
Using rigid polyester plate with foam rubber cushion, size 240x340mm, can absorb operating pressure, improve proofing Repeatability and uniformity, suitable for a variety of substrate testing.
The total film width of 90mm is divided into 10 gaps, the depth is gradually increased by 25μm, and the spacing is 1.5mm. The removable guide plate design is easy to operate on different thickness test panels.
