The device places the test plate in parallel in the wind tunnel, the wind speed control accuracy is 3 +/- 0.3m/s, the drying time is automatically controlled, and the surface crazing can be visually inspected, which is suitable for the evaluation of coating anti-crack performance.
The wind speed is controlled in the range of 3 +/- 0.3m/s, equipped with axial flow fan and automatic timing function, which can simulate the drying process under specified conditions and effectively detect the surface crazing of the material.
The device provides 3 +/- 0.3m/s wind speed through axial flow fan in wind tunnel, Timer delay range of 0.01 seconds to 99 hours 99 minutes, can automatically control drying time and eye test plate surface crazing, support parallel test.
Adopting axial flow fan to supply air, the wind speed can be adjusted steplessly, the wind speed in the wind tunnel is 3 +/- 0.3m/s, and it is equipped with Handheld AnemoMeter measurement, which is suitable for coating drying anti-crack performance testing.
Using axial flow fan and test wind tunnel structure, the wind speed can be adjusted in the range of 3 +/- 0.3m/s, equipped with Timer delay range of 0.01 seconds to 99 hours and 99 minutes, automatic detection of material surface crazing.
The equipment is designed according to the international coating stain resistance experimental method, the water Tank volume is 5L, the inner diaMeter of the flow pipe is 8mm, and the time control range is 0~ 99h99s. It is suitable for the stain resistance test of building exterior coatings.
4-Terminal Resistance Measuring method is used to eliminate the influence of wire resistance. Test speed is up to 6 times/sec. Measurement current is less than 100mA to prevent temperature drift and ensure Precision and Stability.
Using 2-wire method and 3-wire method measurement, Ground Voltage Measurement range 0~ 200V, Ground Resistance Measurement range 0~ 1999 Ω, Response Time about 5 seconds, with continuous measurement and overload protection function.
Double grinding head assembly configuration, total weight 1500g, Reciprocating Frequency 37 +/- 2 times/min, Travel 300mm, can accurately evaluate the stain resistance of the film.
With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
The use of national standard 06Cr19Ni10 stainless steel precision machining, high temperature resistance up to 300 ℃, low temperature resistance to -100 ℃, hardness ≤ 187HB, with acid and alkali resistance, grinding anti-sinking, anti-stick, suitable for dry grinding and wet grinding.
With two test stations, the load range is 50~ 1000g, and three typical wear resistance tests of alcohol, eraser and pencil can be carried out, which is suitable for wear resistance evaluation of various coatings and materials.
Can reduce the contact resistance of 35~ 95% and temperature rise of 35~ 85%, high temperature resistance up to 200 ℃, with anti-oxidation, anti-corrosion performance, suitable for a variety of metal connections, improve safety and stability.
Conical mandrel size is 3.1~ 38 mm, length 203 mm, stainless steel material, wear resistance and corrosion resistance, can test the bending performance of steel, aluminum alloy and plastic sample, easy to operate.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
