The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The bending diaMeter of putty film cracking peeling is tested by bending test plate, and the shaft Rod size is 50mm and 100mm. It is suitable for 0.2-0 mm thick tinplate substrate, and the operation is simple and reliable.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
The equipment can detect the crazing or peeling of the putty film after bending, equipped with R25 and R50 support film specifications, shaft Rod size is 50mm and 100mm in diaMeter, suitable for 0.2-0. 3mm thick tinplate plate.
Made of stainless steel, equipped with three standard film frame thicknesses (0.5/0 7/1.0 mm), drawdown blade inner frame 150 × 70mm, can be stabilized on different substrates Preparative uniform film for subsequent performance testing.
Using a 29.7 × 29mm pump and a 2 kg load weight, the material consistency was accurately determined by the spread diffusion diaMeter of the Basis Weight specimen on the Glass platen, meeting the standard test requirements.
Using ruby probe and digital Probe technology, Measurement range 0-3500 μm, error ≤ +/- ( 3% H + 2 μm), 0.5 seconds fast measurement, can identify iron powder putty layer and a variety of substrate types.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
Equipped with two kinds of shaft Rods with diaMeters of 100mm and 50mm, it can simulate the actual stress conditions, and make the sample uniform bending and deformation through the rolling shaft, which is convenient for observing the phenomenon of film crazing and peeling.
Friction speed 0~ 135cpm, Test Travel 155mm, round-trip count 0~ 9999, suitable for accurate determination of sanding performance of undercoat and putty.
The device uses 20.70ml pump volume and 2kg weight load, which can accurately measure the flow spread diffusion diaMeter of the sample under fixed pressure, ensuring the consistency test, repeability and accuracy.
Equipped with three standard thickness templates (1 +/- 0.05, 0.7 +/- 0.035, 0.5 +/- 0.03), the membrane frame is fixed by spring compression column, which can be prepared for performance testing.
Equipped with R25 and R50 two kinds of support film specifications, support 0.2-0 mm tinplate test plate substrate, through the rolling shaft uniform bending deformation, easy to observe the physical changes of the film.
