Equipped with two kinds of shaft Rods with diaMeters of 100mm and 50mm, it can simulate the actual stress conditions, and make the sample uniform bending and deformation through the rolling shaft, which is convenient for observing the phenomenon of film crazing and peeling.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The equipment can detect the crazing or peeling of the putty film after bending, equipped with R25 and R50 support film specifications, shaft Rod size is 50mm and 100mm in diaMeter, suitable for 0.2-0. 3mm thick tinplate plate.
The bending diaMeter of putty film cracking peeling is tested by bending test plate, and the shaft Rod size is 50mm and 100mm. It is suitable for 0.2-0 mm thick tinplate substrate, and the operation is simple and reliable.
Equipped with R25 and R50 two kinds of support film specifications, support 0.2-0 mm tinplate test plate substrate, through the rolling shaft uniform bending deformation, easy to observe the physical changes of the film.
Friction speed 0~ 135cpm, Test Travel 155mm, round-trip count 0~ 9999, suitable for accurate determination of sanding performance of undercoat and putty.
Measurement accuracy 0.02mm, can control the slow expansion of crazing, test putty layer anti-substrate crazing ability.
Adopting stepless speed regulation technology, the friction speed range is 0~ 135cpm, the test Travel 155mm, the number of times can be set and automatically counted to evaluate the sanding performance of undercoated putty.
Equipped with seven shafts of different diaMeters and a minimum radius of curvature of 0.5mm, the flexibility of the paint film can be accurately measured at 180 ° bending under standard temperature Humidity conditions.
The equipment can perform a 45 ° bending test, support 0.5~ 1.0mm plate thickness, equipped with Travel ≥ 10mm flattening mechanism, suitable for accurate testing of coating flexibility.
The motor-driven edge rises at a rate of 3mm/min to generate and control crazing expansion, which can detect the crazing ability of putty against substrates, with a maximum lift of 20mm, suitable for standard frame 200 × 150mm test plates.
Easy to use magnetic suction Cup loading and unloading, sanding times 0~ 9999 two-way count, friction load 570 +/- 20g, additional weight adjustment load, suitable for undercoating and putty anti-sanding performance test.
It can test the cracking of the paint film after bending 180 degrees in 1-3 seconds, and the diaMeter range of the shaft Rod is 2-32mm. It is suitable for the test plate with a thickness of not more than 1.0mm. Quick evaluation of flexibility.
Equipped with seven steel shaft Rods of different diaMeters, the radius of curvature covers 0.5mm to 7.5mm, and the shaft Rod length is 50mm, which can accurately test the film flexibility under standard temperature Humidity conditions.
Equipped with 7 different diaMeter shaft Rods, the length of the shaft Rod is 35mm, and the minimum radius of curvature is 0.5mm, which can accurately determine the film flexibility according to the standard requirements.
