Using ruby probe and digital Probe technology, Measurement range 0-5000μm, Response speed 0.3s, can intelligently identify iron powder putty layer, and support three-color backlight and custom alarm value prompt.
Using ruby probe and digital Probe technology, Measurement range 0-3500 μm, error ≤ +/- ( 3% H + 2 μm), 0.5 seconds fast measurement, can identify iron powder putty layer and a variety of substrate types.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The bending diaMeter of putty film cracking peeling is tested by bending test plate, and the shaft Rod size is 50mm and 100mm. It is suitable for 0.2-0 mm thick tinplate substrate, and the operation is simple and reliable.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
The equipment can detect the crazing or peeling of the putty film after bending, equipped with R25 and R50 support film specifications, shaft Rod size is 50mm and 100mm in diaMeter, suitable for 0.2-0. 3mm thick tinplate plate.
The pressure range of the probe is 50~ 250N, the diaMeter of the rubber probe is 40mm, and the degree of paint film chalking is evaluated by comparing the imprint of the photo paper with the standard sample, which is suitable for the detection of various environmental factors.
Using a 29.7 × 29mm pump and a 2 kg load weight, the material consistency was accurately determined by the spread diffusion diaMeter of the Basis Weight specimen on the Glass platen, meeting the standard test requirements.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
Equipped with two kinds of shaft Rods with diaMeters of 100mm and 50mm, it can simulate the actual stress conditions, and make the sample uniform bending and deformation through the rolling shaft, which is convenient for observing the phenomenon of film crazing and peeling.
Special design container to ensure measurement conformity, suitable for color scheme, suitable for fine powder particle measurement, effectively avoid the influence of powder tightness and surface Smoothness.
With low temperature OLED display, it can still work normally in -40 ℃ environment; equipped with iron-aluminum dual-use Probe, automatically identify the substrate and convert the mode; Measurement speed is as fast as 0.5 seconds, error range +/- 3%.
Friction speed 0~ 135cpm, Test Travel 155mm, round-trip count 0~ 9999, suitable for accurate determination of sanding performance of undercoat and putty.
