Measurement range 0.0-15 ppm, accuracy +/- 0.3ppm +/- 5% reading, using LED@525nm Illuminant, based on amino acid method for rapid detection of phosphoric acid salts, easy to operate and suitable for laboratory and field.
Using 525nm LED Illuminant, Measurement range 0.0-30 ppm, accuracy +/- 1.0ppm, based on amino acid method to achieve high Sensitivity phosphoric acid salt detection, suitable for a variety of water quality environments.
The samples were treated by acid-base cooking method, and 6 samples could be measured each time. The repeatability error of the absolute value of crude fiber content below 10% did not exceed 0.4%, and the determination time was about 100 minutes.
The PHY Glass membrane is used to withstand strong acid and alkali corrosion, and the membrane Impedance is less than 500MΩ to ensure the measurement Stability; the porous PTFE liquid complex and 3M KCl gel electrolysis solution are designed to improve the anti-pollution performance, suitable for 0-130 ℃ high temperature environment.
Using stainless steel material to ensure acid and alkaline resistance, wet film thickness 100μm accuracy of +/- 2μm, suitable for a variety of pRoduct coating and in line with industry standards.
The stainless steel material has acid and alkaline resistance, wet film thickness 75μm accuracy +/- 2μm, suitable for coating applications of various substrates.
Using stainless steel material with acid and alkaline resistance, wet film thickness 250μm accuracy of +/- 2μm, suitable for flat and sturdy substrate film operation.
Made of stainless steel with good acid and alkaline resistance, wet film thickness 150μm accuracy +/- 2μm, suitable for a variety of pRoducts on flat substrates Spreader applications.
Using stainless steel material acid and alkali resistance, wet film thickness 25μm accuracy +/- 2μm, suitable for flat substrate coating, in line with ASTM multiple test standards.
Using 525nm LED Illuminant to ensure Stability, Measurement range 0-200ppb, accuracy +/- 5ppb, support ascorbic acid detection, with Automatic calibration verification function.
Using stainless steel material acid and alkali, wet film thickness 50μm accuracy +/- 2μm, suitable for flat and solid substrate coating different pRoducts, surface polishing.
Microcrystalline Glass panel resistant to strong acid and alkali, low expansion coefficient to ensure high temperature without deformation, the highest Operating temperature 450 ℃, surrounded by 316L stainless steel material comprehensive corrosion resistance.
Microcrystalline Glass panel is resistant to strong acid and alkali, low expansion coefficient to ensure no deformation at high temperature; Operating temperature 450 ℃, ceramic fiber insulation material is lightweight and efficient, and 316L stainless steel around is corrosion resistant.
Measurement accuracy up to +/- 0.05PH, Repeatability +/- 0.03PH, equipped with LCD large screen display, support data retention and automatic temperature compensation function, easy and reliable operation.
Microcrystalline Glass panel resistant to strong acid and alkali, low expansion coefficient to ensure high temperature without deformation, the highest Operating temperature 450 ℃, 316L stainless steel material comprehensive anti-corrosion, ceramic fiber insulation material lightweight and efficient.
