With manual and automatic temperature compensation function, concentration Measurement range 1 × 10 ^ ²~ 5 × 10 ^ mol/L, the fastest reaction time is less than 4 minutes, support pFe value and iron Ion concentration display.
Gas Sleeve Heating mode is used to heat up quickly and evenly, Temperature Fluctuation +/- 0.5 ℃, carbon dioxide concentration recovery time is short, double door design sealing is good for easy observation, Humidity evaporates naturally.
Support Bluetooth wireless transmission, can access data through mobile devices within 30 Meters. Built-in self-calibrated CO2 Sensor, Measurement range 0-5000ppm, high accuracy and low maintenance cost. At 5 minutes Sampling rate, the battery can support operation for up to half a year.
Using 32-bit microprocessor and 24-bit ADC chip, equipped with 2.4-inch high definition screen, support multi-Sensor and a variety of signal output, with explosion-proof and anti-corrosion design, Response Time ≤ 20s, detection accuracy ≤ +/- 2%.
Pump suction sampling and infrared Sensor technology, range 0~ 2000ppm, resolution 1ppm, Response Time ≤ 20s, with IP65 Protection Rating and Dust Filter, adapt to harsh environment.
Using infrared NDIR detection principle, range 0-500ppm, accuracy ≤ +/- 1% F. S, Response Time ≤ 30 seconds, support 4-20mA, RS485 and wireless signal output, with explosion-proof structure and remote monitoring capability.
4 groups of samples can be tested at the same time, using PID temperature control accuracy of 0.1 ℃, support segmented program heating, one key automatic calculation of carbon black and ash content, open the lid structure heat dissipation fast.
Pump suction sampling and dust design, equipped with dust Filter, Response Time T90 ≤ 20s, detection accuracy ≤ +/- 1%, suitable for harsh industrial environment.
Can simultaneously detect 4 kinds of gases, integrated temperature Humidity detection, support diffusion and pump sampling, with Internet of Things remote monitoring function, Response Time T90 ≤ national standard, Protection Rating IP66, Operating temperature -40~ 55 ℃.
Using infrared NDIR detection principle, Response Time ≤ 30 seconds, detection error ≤ +/- 3% F. S, support 4-20mA, RS485 and switch output, with explosion-proof structure and remote alarm function, Sensor life up to 5 years.
32-Bit microprocessor and 24-bit ADC chip, support 1-6 Sensor expansion, with 4-20mA, RS485 and other output modes, Protection Rating IP65, Response Time T90 ≤ 20s, accuracy ≤ +/- 2%.
Measurement range covers 0~ 5mg/L residual chlorine total chlorine and 0~ 10mg/L chlorine dioxide, support 100 measurements, suitable for water quality testing, easy and fast operation.
4 groups of samples can be tested at the same time, using PID precise temperature control technology, Temperature range from room temperature to 1000 ℃, with automatic calculation of carbon black content and ash content function, open lid structure heat dissipation effect is better.
Using 32-bit microprocessor and 24-bit ADC chip, equipped with 2.4-inch high definition screen, supports 1-6 Sensors and a variety of output modes, with automatic recovery and explosion-proof and anti-corrosion functions, Response Time ≤ 20s, detection accuracy ≤ +/- 1%.
Maximum support for simultaneous detection of 4 gases, integrated temperature and humidity detection, support for diffusion and pump sampling, remote paraMeter configuration and program upgrade functions, Response Time T90 ≤ national standard, Protection Rating IP66.
