The stainless steel pendulum pipe is used to achieve +/- 180 degree swing, equipped with 25 water spray holes and 1-4 rpm adjustable turntable, supporting 50-100kpa water pressure adjustment, and the test water can be recycled without additional waterproof treatment.
Adopt stainless steel pendulum tube to achieve +/- 180 degree swing, equipped with 25 0.4mm nozzles, flow adjustment range 100-1000L/h, support sample holder 1-4 rpm adjustable speed, test water can be recycled.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
Impact accuracy is ensured by double-tube guide structure, the maximum impact energy can reach 320J, the impact height error is controlled within +/- 2mm, and the automatic hammer lifting function is equipped to prevent secondary impact.
With +/- 180 degree swing tube swing and 1~ 4 rpm adjustable sample holder speed, support 50~ 100kpa water spray pressure and 99 hour time setting, and use stainless steel structure to achieve accurate water test.
Using single chip control technology, the impact height can be preset and automatically positioned, the accuracy is up to +/- 1mm, and the secondary impact can be automatically prevented. The mass range of the hammer body is 0.25-15 kg, and the two test methods of passing method and layer method are supported.
Supporting D-type Shore DuroMeter, applying 5kg test force by weight, equipped with Glass bench and adjusting nut to ensure full contact with the sample and improve measurement Stability.
The minimum measurable inner diaMeter is 10mm, the maximum sample thickness is 6mm, and the imported special steel crimp and high-strength pointer components are used. It has good Stability and portability and supports Hardness value conversion.
Four-channel configuration with K-type Thermocouple, the sampling rate can be adjusted from 1 second to 1 minute, and the thermal insulation performance can last for 60 minutes in a 500 ° C environment to achieve full temperature tracking monitoring.
Can be used with A type or C type Shore DuroMeter, fixed load weight mass 0.75 +/- 0.05kg, hardness Gauge clamping Rod connection size M7x0.5mm, improve hardness testing accuracy and Stability.
Using S-type Sensor structure, Measurement accuracy of +/- 0.5%, with 10 data storage and automatic calculation functions, support for automatic conversion of N/kgf/lbf units, peak hold and automatic release functions can be freely set time.
Using S-type external Sensor, Measurement range 10%~ 100% FS, Indication Error less than +/- 0.5%, with peak hold and automatic unit conversion function, support Data storage and sound and light alarm settings.
The dual-channel interface can connect two Probes at the same time, support K-type -200~ 999.9 ℃ wide range, with low power error-proof system and data locking function, waterproof design to adapt to a variety of environments.
High Accuracy S type sensor accuracy of 0.5%, range 0-10KN, with pull-off automatic stop function, three operation modes optional, can directly enter the test block area display force value and strength value
Frequency 7MHz, Probe diaMeter 6mm, can be measured thin-walled and small arc surface, minimum pipe diaMeter Φ 15mm, Measurement range 0.75-80 mm, suitable for different environmental conditions.
