Measured value 50000N, suitable for tape, leather, paper and other sheet or block material push-pull force and destructive force test, supporting the Force Gauge test bench.
Equipped with 10-station synchronous test capability, 1000g weight and 1-999999 minute Timer, using SUS #304 steel plate to ensure test accuracy, and automatically recording tape peeling time.
The adhesive force of the tape is 4.3N/cm, and the principle of cross-cut method is adopted, which is suitable for adhesion testing. The performance is stable and non-degumming, and the test results are accurate and reliable.
Hydraulic automatic pull-off test, the pull-off speed is stable and controllable, the accuracy is +/- 1% full scale, equipped with pull-off kit size 10-50mm, built-in rechargeable battery and 200,000 Data storage.
11/16 inch standard width paper tape, capable of completing approximately 1800 cycles of testing per roll, must be stored at 23 +/- 2 ° C and 50 +/- 10% Humidity to ensure Stability.
Adopt replica tape method to measure surface roughness, Peak Measurement range 20~ 115μm, accuracy +/- 5μm, with automatic subtracting substrate function, High Protection Rating, anti-solvent and water dust.
Measured value 500N, suitable for tape, PCB, adhesive tape and other materials disbonding force test, supporting the Force Gauge test bench.
Using 2000g +/- 5g roller load and 300mm/min rolling speed to ensure that the adhesive tape sample is flat and evenly adhered to the standard substrate, in line with CNS-11888 and PSTC-8 design standards.
Maximum load 0.5KN, specially designed for pull ring samples, compact structure, easy installation, suitable for tensile testing of a variety of materials, providing reliable data support.
Measured value 500N, suitable for sheet, block material push-pull and destructive force test, can be used with Force Gauge test stand.
Measured value up to 5000N, suitable for sheet and block material push-pull force and destructive force test, supporting the Force Gauge test bench.
Portable design built-in lithium battery, 0-3000p range accuracy +/- 1%, equipped with 10-50mm pull-off spindle, automatic calculation of pull-off force without conversion table, aluminum alignment unit to ensure uniform testing.
Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
Measured value 5000N, suitable for the push-pull force and destructive force test of bakelite block, Glass, leather, paper and other sheet or block materials.
Measured value 500N, suitable for the push-pull force and destructive force test of bakelite block, Glass, leather, paper and other sheet and block materials.
